Használati útmutató SkyRC e4

SkyRC Akkumulátor töltő e4

Olvassa el alább 📖 a magyar nyelvű használati útmutatót SkyRC e4 (4 oldal) a Akkumulátor töltő kategóriában. Ezt az útmutatót 12 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/4
Thank you for your choice of the SKYRC e4, 100-240V AC balance charger. This unit is simple to use but
its operation does require some knowledge on the part of the user. Please read this entire operating
manual completely and attentively before using this product, as it covers a wide range of information on
operating and safety.
SKYRC e4 Charger is an economic, high quality 100-240V AC balance charger, designed for charging
LiPo and LiFe batteries from 2-4 cells in balance mode. The circuit power is 20W and max charge current
can reach to 3A. There are three kinds of charge current 1A/2A/3A that can be selected. You could select
the proper charge current according to battery capacity.
INSTRUCTION MANUAL
INTRODUCTION
CHARGE PROCEDURES
SKYRC e4 comes with the built in power supply. You can connect the AC power cord to the AC socket
(100-240V AC) directly.
Insert the AC power cord into the charger.
Insert the AC cord into a wall socket (100-240V). All LEDS will light for 1 second and the charge
status LED will flash green which indicates the charger is ready to charge.
Select the battery type LiPo/LiFe by the toggle switch.
Select the proper charging current 1A/2A/3A by the toggle switch.
Connect the battery main charge lead to battery socket which is in the front side of the charger and
battery balance wire to balance port which is in the right side of the charger.
The charger starts charging. The charge status LED and the cell status LED will glow constant red. If
the battery pack is 2-cell, Cell 1 and Cell 2 LEDs will glow constant red; if the battery pack is 3-cell,
Cell 1, Cell 2 and Cell 3 LEDs will glow constant red; and so on.
During the charging progress, when the charge
status LED glows constant red, the charger is
charging in CC mode; when the charge status
LED glows constant orange, the charger is
charging in CV mode;
When the cell LED is flashing, this cell is
discharging for balancing.
When the battery is fully charged, the charge
status LED will glow constant green.
Unplug the battery from the charger and the
charge status LED will flash green which
indicates the charger is ready to charge
another battery.
Please refer to following steps to charge the battery,
1)
2)
3)
4)
5)
6)
7)
8)
9)
- - - -1 2
SPECIFICATION
AC Input
Battery Type
Cell Count
Charge Current
Circuit Power
Current Drain for Balancing
Dimension
Weight
Charger/Cell Status
100-240V
LiPo/LiFe
2-4 cells
1A/2A/3A ± 10%
20W
200mA
69.4x110.7x40.5mm
176g
SK-100055
This diagram shows the correct way to connect your
battery to the e4 charger while charging in balance
mode.
Failure to connect as shown in this diagram will
damage this charger.
CAUTION:
CONNECTION DIAGRAM
Charger
Battery
10)
Battery Type Switch
Cell 2 LED Indicator
Cell 1 LED Indicator
Cell 4 LED Indicator
Cell 3 LED Indicator
Battery Socket
AC 100-240V
Power Jack
Charge Current Switch
Charge Status LED Indicator
Balance Socket
EXPLANATION OF LED STATUS
If the charger encounters a problem, all LEDs will flash red in sequence to alert you the errors. In this
case, please disconnect the power cord from the wall socket and unplug the battery from the charger.
* Error Message
LED green blinking
LED glows constant red
LED glows constant orange
LED glows constant green.
LED glows constant red.
LED flashes red
The charger is ready to charge.
The charger is charging in CC mode.
The charger is charging in CV mode.
The charging process finishes.
The cell is charging.
The cell is discharging.
Charge Status LED
Cell Status LED
7504-0293-01
Manufactured by
SKYRC TECHNOLOGY CO LTD ., .
www skyrc com. .
- - - -3 4
THE SET CONTAINS WARNING AND SAFETY NOTES
SKYRC e4 is suitable for charging rechargeable LiPo/LiFe batteries. Do not attempt to recharge dry
cells. Charging other types of batteries may cause fire or explosion.
Never leave the charger unattended when it is connected to its power supply.
The allowable AC input voltage is 100-240V AC. Never connect it to any other voltage.
Protect charger from dust, dirt and damp.
Never place the charger and batteries connected to it on any form of flammable surface. Never
operate the charger in the vicinity of inflammable material or gas.
Ensure that there is an unrestricted airflow to and from the charger's cooling slots. Never place the
charger on a carpet or similar surface.
Take great care to maintain correct battery polarity, and avoid shot-circuit. Read the battery
manufacturer's instructions and adhere to them strictly.
WARRANTY AND SERVICE
We guarantee this product to be free of manufacturing and assembly defects for a period of one year
from the time of purchase. The warranty only applies to material or operational defects, which are present
at the time of purchase. During that period, we will repair or replace free of service charge for products
deemed defective due to those causes.
You will be required to produce proof of purchase (invoice or receipt). This warranty is not valid for any
damage or subsequent damage arising as a result of misuse, modification or as a result of failure to
observe the procedures outlined in this manual.
LIABILITY EXCLUSION
This charger is designed and approved exclusively for use with the types of battery stated in these
Instruction Manual. SKYRC accepts no liability of any kind if the charger is used for any purpose other
than that stated. We are unable to ensure that you follow the instructions supplied with the charger, and
we have no control over the methods you employ for using, operating and maintaining the device. For this
reason we are obliged to deny all liability for loss, damage or costs which are incurred due to the
incompetent or incorrect use and operation of our products, or which are connected with such operation
in any way. Unless otherwise prescribed by law, our obligation to pay compensation, regardless of the
legal argument employed, is limited to the invoice value of those SKYRC products which were
immediately and directly involved in the event in which the damage occurred.
SkyRC e4 Charger
AC Power Cord
18AWG Wire Charging Cable
RECOMMENDED ACCESSORIES
Tamiya charging cable
5201-0030-01
TRAXXAS charging cable
5201-0033-01
Crocodile clip
charging cable
5201-0031-01
EC3 charging cable
5201-0034-01
Dean charging cable
5201-0012-01
Futaba RX charging cable
JST/BEC charging cable
5201-0044-015201-0043-01
CONFORMITY DECLARATION
SKYRC e4 satisfies all relevant and mandatory CE directives and FCC Part 15 Subpart B: 2008.
The product has been tested to meet the following technical standards:
This symbol means that you must dispose of electrical devices from the general household
waste when it reaches the end of its useful life. Take your charger to your local waste
collection point or recycling centre. This applies to all countries of the European Union, and to
other European countries with a separate waste collection system.
Conform
Conform
Conform
CE-EMC
FCC-VOC FCC Part 15B
Electromagnetic compatibility (EMC) -- Part 6-3:
Genericstandards - Emission standard for residential,
commercial andlight-industrial environments.
Electromagnetic compatibility (EMC) -- Part 6-1: Generic
standards - Immunity for residential, commercial and
light-industrial environments.
EN61000-6-1
EN61000-6-3
Test Standards Title Result
Electromagnetic compatibility (EMC), Conduction Emission
& Radiation Emission.
Conform
EN61000-3-3
Electromagnetic compatibility (EMC) - Part 3-3: Limits -
Limitation of voltage changes, voltage fluctuations and
flicker in public low-voltage supply systems, for
equipment with rated current 16 A per phase and not
subject to conditional connection.
EN61000-3-2
Electromagnetic compatibility (EMC) –
Part 3-2: Limits – Limits for harmonic current emissions
(equipment input current 16 A per phase)≤
Conform
EN60335-2-29
CE-LVD
Household and similar electrical appliances –. Safety –.
Part 2-29: Particular requirements for battery chargers.
Conform

Termékspecifikációk

Márka: SkyRC
Kategória: Akkumulátor töltő
Modell: e4

Szüksége van segítségre?

Ha segítségre van szüksége SkyRC e4, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Akkumulátor töltő SkyRC

SkyRC

SkyRC B6AC+ V2 Útmutató

15 Augusztus 2024
SkyRC

SkyRC SK-100059-01 Útmutató

14 Augusztus 2024
SkyRC

SkyRC B6 nano Útmutató

13 Augusztus 2024
SkyRC

SkyRC e680 Útmutató

12 Augusztus 2024
SkyRC

SkyRC iMAX B6mini Útmutató

11 Augusztus 2024
SkyRC

SkyRC D260 Útmutató

10 Augusztus 2024
SkyRC

SkyRC e450 Útmutató

10 Augusztus 2024
SkyRC

SkyRC E6 Útmutató

10 Augusztus 2024
SkyRC

SkyRC NC2600 Útmutató

10 Augusztus 2024
SkyRC

SkyRC B6 nano duo Útmutató

9 Augusztus 2024

Útmutatók Akkumulátor töltő

Legújabb útmutatók Akkumulátor töltő

Schwaiger

Schwaiger LAD230 531 Útmutató

9 Április 2025
Schwaiger

Schwaiger 658699 Útmutató

9 Április 2025
Schwaiger

Schwaiger LAD440 532 Útmutató

9 Április 2025
Ergotron

Ergotron 97-939 Útmutató

3 Április 2025
Ergotron

Ergotron YES35 Útmutató

3 Április 2025
Trust

Trust Maxo 25242 Útmutató

3 Április 2025
Ergotron

Ergotron LiFeKinnex Útmutató

3 Április 2025
Voltcraft

Voltcraft PB-19C Útmutató

31 Március 2025
Watson

Watson 9V-2BC Útmutató

30 Március 2025
ISDT

ISDT Q6 Lite Útmutató

26 Március 2025