Használati útmutató Privileg RSIO 3T224 E

Privileg mosogatógép RSIO 3T224 E

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Privileg RSIO 3T224 E (8 oldal) a mosogatógép kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/8
EN
1
DAILY REFERENCE
GUIDE
Before using the appliance carefully read Health and Safety guide.
APPLIANCE
PRODUCT DESCRIPTION
CONTROL PANEL
1. Upper rack
2. Foldable aps
3. Upper rack height adjuster
4. Upper spray arm
5. Lower rack
6. Space Zone
7. Cutlery basket
8. Lower spray arm
9. Filter Assembly
10. Salt reservoir
11. Detergent and Rinse Aid dispensers
12. Rating plate
13. Control panel
1. On-O/Reset button with indicator light
2. Program selection button
3. Salt rell indicator light
4. Rinse Aid rell indicator light
5. Program number and delay time indicator
6. Display
7. Delay indicator light
8. Half Load indicator lights
9. Push & Go button
10. Delay button
11. Half Load button with indicator light
12. Tablet (Tab) button with indicator light
13. Start/Pause button with indicator light
1
2
3
4
57
8
10
9
13
0000 000 00000
S i :erv ce
1112
6
1 2 3 4 5 6 7 8 9 10 11 12 13
You can download the Safety Instructions and the Use and Care Guide, by visiting our website
docs.whirlpool.eu and following the Instructions on the back of this booklet.
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the reta-
ining elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machine’s functional components.
It is important that the salt reservoir be never empty.
It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher (see PRO
DUCT DESCRIPTION) and should be lled when the SALT REFILL indi-
cator light in the control panel is lit .
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. -Only the rst time you do this: ll the salt re
servoir with water.
3. Position the funnel (see gure) and ll the salt
reservoir right up to its edge (approximately
1 kg); it is not unusual for a little water to leak
out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, it is mandatory to complete the
procedure before the beginning of the washing cycle.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier.
The factory setting is for average (3) water hardness.
Switch on the appliance by pressing the button.ON/OFF
Switch o the appliance by pressing the button.ON/OFF
Hold down button for 5 seconds, until you hear a beep.P
Switch on the appliance by pressing the button.ON/OFF
The current selection level number and the salt indicator light both
ash.
Press button to select the desired hardness level (Psee WATER HARD-
NESS TABLE).
Switch o the appliance by pressing the button.ON/OFF
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been specically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indi-
cator light switches o.
If the salt container is not lled, the water softener and the
heating element may be damaged as a result.
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser shouldA
be lled when the RINSE AID REFILL indicator light in the control
panel is lit.
1. Open the dispenser by pressing and pulling up the tab on the lidB .
2. Pour in the rinse aid (max.110 ml), making sure it does not overow
from the dispenser. If this happens, clean the spill immediately with a
dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satised with the drying results, you can ad-
just the quantity of rinse aid used.
Switch the dishwasher on using the button.ON/OFF
Switch it o using the button.ON/OFF
Press button three times - a beep will be heard.P
Switch it on using the button.ON/OFF
The current selection level number and rinse aid indicator light ash.
Press button to select the level of rinse aid quantity to be supplied.P
Switch it o using the buttonON/OFF
Setting is complete!
If the rinse aid level is set to ZERO (ECO), no rinse aid will be supplied.
The LOW RINSE AID indicator light will not be lit if you run out of rinse
aid.
A maximum of 5 levels can be set according to the dishwasher model.
The factory setting is specic to the model, please follow instruction
above to check this for your machine.
If you see bluish streaks on the dishes, set a low number (1-2).
If there are drops of water or limescale marks on the dishes, set a
mid-range number (3-4).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device A.
Introduce the detergent into the dry
dispenser B only. Place the amount
of detergent for pre-washing directly
inside the tub.
1. When measuring out the detergent re-
fer to the mentioned earlier information
to add the proper quantity. Inside the
dispenser B there are indications to help
the detergent dosing.
2. Remove detergent residues from the
edges of the dispenser and
close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time ac-
cording to the program.
If all-in-one detergents are used, we recommend using the TABLET
button, because it adjusts the program so that the best washing and
drying results are always achieved.
Water Hardness Table
Level °dH
German degrees
°fH
French degrees
1 Soft 0 - 6 0 - 10
2 Medium 7 - 11 11 - 20
3 Average 12 - 17 21 - 30
4 Hard 18 - 34 31 - 60
5 Very hard 35 - 50 61 - 90
A
B
A
B
EN
3
PROGRAMS TABLE
Program
Drying
Available
options*)
Detergent
container Duration
of wash
program
(h:min)**)
Water con-
sumption
(litres/cycle)
Energy con-
sumption
(kWh/cycle)
Tub B
1Eco 50° 4:00 9.0 0.74
2Auto
Intensive 65° - 2:20 - 3:00 16.0 - 18.0 1.20 - 1.40
3Auto
Normal 55° 2:10 - 2:50 14.5 - 16.0 1.05 - 1.25
4Delicate
45°
- 1:40 12.0 1.00
5Rapid 30’ 50° - - 0:30 9.0 0.50
6Silent 50° - 3:35 16.5 1.00
7Extra 65° - - 1:30 12.0 1.20
8Pre-Wash - - --0:10 4.5 0.01
9Push&GO 50° - 1:20 10.0 1.10
Instructions on wash cycle selection.
1 ECO
Normally soiled crockery. Standard program, the most ecient in
terms of its combined energy and water consumption.
2 AUTO INTENSIVE
Automatic program for heavily soiled dishes and pans (not to be used
for delicate items).
3 AUTO NORMAL
Automatic program for normally soiled pans and dishes.
4 DELICATE
Program for delicate items, which are more sensitive to high tempera-
tures, for example glasses and cups.
5 RAPID 30’
Program to be used for lightly-soiled dishes with no dried food resi-
dues.
6 SILENT
Suitable for night-time operation of the appliance. Ensures optimal
cleaning and drying performance with the lowest noise emission.
7 EXTRA
Program that allows to wash very big items loaded in the lower rack.
8 PRE-WASH
Use to refresh crockery planned to be washed later. No detergent to be
used with this program.
9 PUSH & GO
Everyday wash and dry cycle that ensures great cleaning performance
in a short time without the need to pre-treat dishes.
Notes:
Please note that cycles like Rapid or Fast are most eective for lightly
soiled dishes.
To reduce consumption even further, only run the dishwasher
when it is full.
PROGRAMS DESCRIPTION
ECO program data is measured under laboratory conditions according to European Standard EN 50242.
Note for Test Laboratories:
For information on comparative EN testing conditions, please send an email to the following address: dw_test_support@whirlpool.com
Pre-treatment of the dishes is not needed before any of the programs.
*) Not all options can be used simultaneously.
**) The duration of the program shown on the display or in the booklet is an estimate calculated on standard conditions. The actual time may vary
depending on many factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load,
load balancing, additional selected options and sensor calibration. The sensor calibration can increase program duration up to 20 min.
Standby consumption: Left-on mode consumption: 5 W - O mode consumption: 0.5 W

Termékspecifikációk

Márka: Privileg
Kategória: mosogatógép
Modell: RSIO 3T224 E

Szüksége van segítségre?

Ha segítségre van szüksége Privileg RSIO 3T224 E, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók mosogatógép Privileg

Útmutatók mosogatógép

Legújabb útmutatók mosogatógép