Használati útmutató Panduit WBH6E

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Panduit WBH6E (1 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/1
INSTALLATION INSTRUCTIONS
NETWORK CONNECTIVITY GROUP
© Panduit Corp. 2002 Printed in U.S.A.
WORLDWIDE SUSIDIARIES AND SALES OFFICES
412 Rockwell Court
Burr Ridge, Illinois 60521
Technical Support: 866-405-6654
Fax: 708-444-6993
E-mail: netconnsupport@panduit.com
Web site: www.panduit.com/ncg
Page 1 of 1
CM23A
HINGED WALL MOUNT BRACKET
PART NUMBERS: WBH1, WBH2, WBH3, WBH4,
WBH2E, WBH4E, WBH6E
TO MOUNT BRACKET TO WALL OR 19RACK:
1. Determine desired wall or rack mounting location.
2. Insert appropriate hardware (screws not included) through keyways in rear of bracket and
fasten securely to wall, or insert through round holes and fasten securely to rack..
3. Hinged bracket is removable so that equipment can hinge open on either side.
TO INSTALL EQUIPMENT ON BRACKET:
1. Determine desired mounting location for equipment.
2. Align equipment on bracket.
3. Insert #12-24 screws (not included) into equipment and screw into mounting bracket holes
on either side .
4. To access back of equipment, remove L-bracket screws.
NOTE: WBHE models are packaged without hinges or L-brackets installed. Mount hinges
and L-brackets on the outside of the Main Bracket as shown, using the supplied #12-24
screws and pem nuts.Make certain the pem nuts are facing the back of the Main Bracket.
L-Bracket for
quick access to
back of panels
Back opening for in wall
cable access
Main BracketHinged Bracket
Hinged Bracket
Screws
Cable Tie
or Tak-Ty
slots

Termékspecifikációk

Márka: Panduit
Kategória: nincs kategorizálva
Modell: WBH6E

Szüksége van segítségre?

Ha segítségre van szüksége Panduit WBH6E, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók nincs kategorizálva Panduit

Útmutatók nincs kategorizálva

Legújabb útmutatók nincs kategorizálva