Használati útmutató Metra 99-8907HG

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Metra 99-8907HG (8 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 4 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/8
METRA. The World’s best kits.metraonline.com © COPYRIGHT 2015 METRA ELECTRONICS CORPORATION
REV. 11/3/2015 INST99-8907HG
CAUTION: Metra recommends disconnecting the negative battery
terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your
local Dealership for more information. All accessories, switches,
climate controls panels, and especially air bag indicator lights
must be connected before reconnecting the battery or cycling
the ignition. Also, do not remove the factory radio with the key
in the on position, or the vehicle running. It would be best to
remove the key from the ignition and then wait a few seconds
before removing the factory radio.
Installation instructions for part 99-8907HG
ISO DIN radio provision with pocket
Painted two-tone silver and gloss black
A) Radio trim panel • B) Radio brackets C) Pocket • D) (2) Metal speed clips
E) (2) #10 x 3/4 Phillips screws F) (4) #8 x 3/8” Phillips screws
20;-,(;<9,:
20;*64765,5;:
>0905.(5;,55(*655,*;065: (sold separately)
Wiring Harness: • 70-1761 Antenna Adapter:40-LX11
Panel removal tool • Phillips screwdriver
10 mm socket wrench and long extension
;663:9,8<09,+
Subaru Impreza and Crosstrek 2015-up
99-8907HG
A C DFE
B
Dash Disassembly ..............................................2-5
Kit Assembly
ISO DIN radio provision with pocket ...................... 6
Table of Contents
99-8907HG
2
Dash Disassembly
1. Unsnap and remove the outside
trim panel from the driver’s side
dash. (Figure A)
2. Remove (2) Phillips screws from
the driver knee trim panel and
remove the panel. (Figure B)
3. Remove (2) 10 mm nuts now
exposed and lower the driver
airbag assembly (no need to
disconnect). (Figure C)
Continued on next page (Figure A) (Figure B) (Figure C)
99-8907HG
4. Release the glove box retaining
cable, squeeze the sides and lower
the glove box. (Figure D)
5. On both sides unclip and remove
the climate control cables,
accessed under the dash on the
driver side and through the glove
compartment opening on the
passenger side. (Be sure to watch
where the cables are routed).
Note, this step is not necessary
in vehicles with automatic
climate controls. (Figure E, F)
Continued on next page
3
Dash Disassembly
(Figure D) (Figure E) (Figure F)
Passenger side
Driver’s side

Termékspecifikációk

Márka: Metra
Kategória: nincs kategorizálva
Modell: 99-8907HG

Szüksége van segítségre?

Ha segítségre van szüksége Metra 99-8907HG, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók nincs kategorizálva Metra

Útmutatók nincs kategorizálva

Legújabb útmutatók nincs kategorizálva

MOZA

MOZA SR-P Útmutató

10 Április 2025
CaterChef

CaterChef 445001 Útmutató

9 Április 2025
IFM

IFM E40581 Útmutató

9 Április 2025
Livn

Livn Bolt Útmutató

9 Április 2025
Livn

Livn Beats Útmutató

9 Április 2025
IFM

IFM O3R252 Útmutató

9 Április 2025