Használati útmutató M-System MSU-50

M-System Páraelszívó MSU-50

Olvassa el alább 📖 a magyar nyelvű használati útmutatót M-System MSU-50 (20 oldal) a Páraelszívó kategóriában. Ezt az útmutatót 10 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF

Oldal 1/20

INSTRUCTIONS FOR INSTALLATION AND USE

MONTAGE- UND GEBRAUCHSANWEISUNG

INSTRUCTIONS POUR L'INSTALLATION ET L’UTILISATION

ISTRUZIONI PER L'INSTALLAZIONE E L’USO

INSTRUCCIONES PARA INSTALACIÓN Y USO

INSTRUÇÕES DE INSTALAÇÃO Y UTILIZAÇÃO

AANWIJZING VOOR GEBRUIK EN INSTALLATIE

ENGLISH

DESCRIPTION

The hood may be installed in the filtering or the ducting version. Filtering version (Fig. 1): The hood aspirates the

kitchen air saturated with fumes and odours, purifies it through the grease filters and charcoal filters and returns clean

air into the room. For constant efficiency, the charcoal filters must be replaced periodically. The charcoal filters are not

supplied. Ducting version (Fig. 2): The hood aspirates the kitchen air saturated with fumes and odours, passes it through

the grease filters and expels it to the outside through an outlet pipe. With this version the charcoal filters are not required.

Decide from the outset on the type of installation (filtering or ducting). For greater efficiency, we recommend you install

the hood in the ducting version (if possible).

INSTALLATION

ATTENTION: The appliance should be installed by a qualified operator.

INSTALLATION IN DUCTING VERSION:

1. Before fixing, the disposal duct for air evacuation to the outside must be installed. Use an disposal duct with:

– minimum indispensable length; – minimum possible bends (maximum angle of bend: 90°); – certified material (according

to the State); – an as smooth as possible inside. It is also advisable to avoid any drastic changes in pipe cross-section.

We recommend using a 150 mm diameter pipe. For air evacuation to the outside, follow all the other instructions given

on the “Warnings” sheet.

2. Prepare a suitable power supply. For the electrical connection, follow all the other instructions on the “Warnings”

sheet.

3. Cut a hole in the bottom of the pensile cupboard in order to settle the appliance (Fig. 3). The pensile cupboard

bottom must be 16 mm thick. Check that the fixing tabs (Fig. 4) to the wall unit are positioned at a height suited to the

thickness of the bottom of the wall unit. If this distance is less than the thickness, increase it by unscrewing the 2

corresponding screws inside the hood.

4. Insert the appliance in the hole (Fig. 3).

5. Tighten the 2 screws inside the appliance (Fig. 6) until it fits snug on the bottom of the wall unit. Do not tighten

the two screws strongly to maintain the two metallic clamps in the right position.

6. Connect the disposal duct to the air evacuation pipe of the hood. Use a flexible pipe and lock it to the air evacuation

pipe of the hood with a metal hose clamp (pipe and clamp are not provided). Make the electrical connections.

INSTALLATION IN FILTERING VERSION:

Proceed with installation, making reference to the instructions for the extraction version (see points 2, 3, 4, 5), and

then follow the instructions below.

Connect the hose to the hood air outlet so the air is conveyed to the top of the wall unit; secure the hose with a metal

clamp (hose and clamp are not provided). Make power connections.

Check whether the charcoal filter(or canister) is already installed; if not, assemble it as follows: open the metal panel

and remove the grease filter (Fig. 6); install the charcoal filter: rest the charcoal filter on the motor unit by making the

pins coincide; turn the charcoal filter until this is fast (Fig. 7).

Re-assemble the grease filter and close the metal panel.

DEVICE DISASSEMBLY

During the following operations always support the device.

Tighten the 2 screws inside the device (Fig. 5); moving the 2 small tongues toward the device inside using the right

carvings (Fig. 8); pull out the device from its side.

OPERATION

Depending on the model, the unit is equipped with the following controls:

Controls shown in Fig. 9:

A) Turns the lights off.

B) Turns the lights on.

C) Reduces the motor speed until reaching zero. If pressed for 2" when the Filter Alarm is active, the HOUR counter is

reset.

D) Drives the motor (calling the last speed used) and increases the speed until reaching maximum.

E) Activates/deactivates the sensor (AUTOMATIC or MANUAL mode). In Automatic mode the sensor is active and the

letter “A” appears on the display (L).

L) Display:

- signals the running speed

- signals Automatic mode by displaying the letter “A”. When the motor speed is changed, the running speed is displayed

flashing 3 times, and then the letter “A” reappears.

- signals the filter alarm (with motor off) by displaying the central segment for 30".

Termékspecifikációk

Márka:	M-System
Kategória:	Páraelszívó
Modell:	MSU-50

Szüksége van segítségre?

Ha segítségre van szüksége M-System MSU-50, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek

Az Ön neve*

Az Ön e-mail címe*

Írja ide kérdését

Útmutatók Páraelszívó M-System

M-System MSPK 761 IX Útmutató

15 Október 2024

M-System EK-9 GALASSIA Útmutató

29 Szeptember 2024

M-System MSPK 1261 Útmutató

5 Szeptember 2024

M-System MU-50 Útmutató

10 Augusztus 2024

M-System MSPK 760 IX Útmutató

7 Augusztus 2024

M-System MSDK 660 Útmutató

3 Augusztus 2024

M-System MSPK 660 IX Útmutató

3 Augusztus 2024

M-System MST-90 Útmutató

31 Július 2024

M-System MSK-650IX Útmutató

30 Július 2024

M-System MSPK 901 Útmutató

30 Július 2024

Útmutatók Páraelszívó

Legújabb útmutatók Páraelszívó

AEG 835 D Útmutató

4 Április 2025

Electrolux EFC 9710 Útmutató

4 Április 2025

Electrolux NB 7902 Útmutató

4 Április 2025

Atag wg 811 l luna rvs Útmutató

4 Április 2025

Whirlpool AKR 400 Útmutató

4 Április 2025

Eudora 3LIK0148 Útmutató

4 Április 2025

CATA F WH Útmutató

4 Április 2025

Candy CBT9240 Útmutató

3 Április 2025

AEG-Electrolux CHDF 6260 Útmutató

3 Április 2025

Hanseatic SY-103E13-E4-C55-L52-900 Útmutató

3 Április 2025