Használati útmutató Kenwood KMC-36

Kenwood rádió KMC-36

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Kenwood KMC-36 (7 oldal) a rádió kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/7
Document Copyrights
Copyright 2006 by Kenwood Corporation. All rights reserved.
No part of this manual may be reproduced, translated, distributed, or transmitted in any
form or by any means, electronic, mechanical, photocopying, recording, or otherwise, for
any purpose without the prior written permission of Kenwood.
Disclaimer
While every precaution has been taken in the preparation of this manual, Kenwood
assumes no responsibility for errors or omissions. Neither is any liability assumed for
damages resulting from the use of the information contained herein. Kenwood reserves
the right to make changes to any products herein at any time for improvement purposes.
© 2004-7 PRINTED IN JAPAN
B51-8697-00 (N) 1309
MICROPHONE / KEYPAD MICROPHONE
KMC-35/36
SERVICE MANUAL
1E30-7531-08 CURL CABLE
2 E58-0475-05 MODULAR JACK
3G01-4546-08 COIL SPRING (PTT)
4G53-1646-08 PACKING
5J19-5479-08 MIC HOLDER
6J19-5482-05 MIC HANGER (ACCESSORY)
7K29-9333-08 LEVER KNOB (PTT)
8K29-9334-08 KNOB (PTT)
9K29-9335-08 KEY TOP KMC-36
A N52-3012-60 PAN HEAD TAPPING SCREW
10 S70-0499-08 TACT SWITCH
11 T91-0538-05 MIC ELEMENT
New
parts
Ref. No. Parts No. Description Destination
KMC-35 (Y58-3740-20), KMC-36 (Y58-3750-20) : New parts
PARTS LIST
KMC-35
KMC-36
Lever knob (PTT)
(K29-9333-08) Curl cable
(E30-7531-08)
Lever knob (PTT)
(K29-9333-08) Curl cable
(E30-7531-08)
Key top
(K29-9335-08)
KMC-35/36
2
Main PCB removal
1. Remove the four screws, the rear case and all-round pack-
ing.
2. Lift the switch PCB and remove it from the front case.
( )q
q
Switch PCB
w
Main PCB
q
w
qw
DISASSEMBLY FOR REPAIR
3. Lift the upper part of the Main PCB using a pair of twee-
zers ( ) and remove the Main PCB.w
Main PCB installation procedure
1. Install the microphone holder, spacer and keytop (KMC-36
only) on the front case.
2. Tilt the Main PCB and fit the modular connector into the
front case first.
3. Hold the modular connector with your fingers and move it
in the direction indicated by the arrow to install the Main
PCB onto the front case.
PTT knob installation procedure
1. Place the PTT knob in the front case diagonally as shown
in the figure.
2. Hold down the upper part of the PTT knob ( ) and pushq
the PTT knob shaft down ( ) to install the PTT knob ontow
the front case.
Hot microphone modification procedure
1. Lift the jumper with a pair of tweezers or similar tool. ( q)
Note : The jumper is bonded to the board, but not strongly
fixed, so it can be detached by applying light force.
2. Cut the base of the jumper into two parts with a pair of
nippers or similar tool. ( w)

Termékspecifikációk

Márka: Kenwood
Kategória: rádió
Modell: KMC-36

Szüksége van segítségre?

Ha segítségre van szüksége Kenwood KMC-36, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók rádió Kenwood

Kenwood

Kenwood CR-ST90S Útmutató

11 Január 2025
Kenwood

Kenwood KTC-HR200 Útmutató

30 Augusztus 2024
Kenwood

Kenwood KMC-47GPS Útmutató

15 Augusztus 2024
Kenwood

Kenwood KMC-45D Útmutató

11 Augusztus 2024
Kenwood

Kenwood KRK-10 Útmutató

11 Augusztus 2024
Kenwood

Kenwood KNB-57L Útmutató

11 Augusztus 2024
Kenwood

Kenwood PMR446 Útmutató

5 Augusztus 2024
Kenwood

Kenwood CR-M30DAB Útmutató

1 Augusztus 2024

Útmutatók rádió

Legújabb útmutatók rádió

Muse

Muse M-025 RW Útmutató

10 Április 2025
Denver

Denver CRQ-110 Útmutató

2 Április 2025
Muse

Muse MF-060 VB Útmutató

1 Április 2025
Muse

Muse MF-060 AG Útmutató

1 Április 2025
Difrnce

Difrnce DBB300 Útmutató

31 Március 2025
RoadKing

RoadKing 56 Útmutató

29 Március 2025
Bush

Bush DS982 Útmutató

26 Március 2025
DeWalt

DeWalt DCA2203C Útmutató

25 Március 2025
Albrecht

Albrecht DR-330 Útmutató

16 Január 2025