Használati útmutató JL Audio Evolution TR650-CSi

JL Audio hangszóró Evolution TR650-CSi

Olvassa el alább 📖 a magyar nyelvű használati útmutatót JL Audio Evolution TR650-CSi (5 oldal) a hangszóró kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/5
Thank you for choosing a JL Audio Evolution TR Component System
for your automotive sound system. With proper installation, your
new speakers will deliver years of listening pleasure.
We strongly recommend that you have your new Evolution speakers
installed by your authorized JL Audio dealer. The installation
professionals employed by your dealer have the necessary tools and
experience to disassemble your interior panels, install your new
speakers and reassemble your vehicle properly. Also, keep in mind
that your warranty coverage doubles to 2 years if your system is
installed by your authorized JL Audio dealer. If you prefer to perform
your own installation, please read this instruction manual
completely before beginning the process.
TR650-CSi
6.5-inch (160 mm) 2-Way Component System
o w n e r ’ s m a n u a l
BUILT-IN TWEETER
PROTECTION CIRCUITRY:
The TR Crossover networks are equipped with
an advanced electronic tweeter protection circuit
designed to minimize the possibility of tweeter
failure. This electronic device monitors current going
to the tweeter and will disconnect the tweeter from
the signal when it senses overload. Should this occur
while listening to the audio system, simply reduce the
volume for a few seconds and the protection circuit
will reset itself automatically.
SPEAKER PLACEMENT
CONSIDERATIONS:
A component system gives you the ability to
place the woofer and tweeter separately in your
vehicle interior.This can be good or bad, depending
on how it’s done.
As a general rule, the tweeters should be placed
relatively close to the woofers for best tonal balance
and most coherent imaging (the closer, the better).
Any separation greater than 8 inches (20 cm) is
likely to result in degraded sound quality.
Avoid placing tweeters where they will be
blocked by objects in the interior of the car
(including seated occupants). When selecting a
mounting location, look at both sides of the car to
make sure that this location is clear on both sides.
You can always experiment with tweeter
placement before committing to a final mounting
location. Simply connect the rest of the system and
allow plenty of wire length for the tweeters. Using
velcro or similar material, attach the tweeters in
different locations until you find the one where they
perform best.
Woofers will usually be placed into factory
speaker locations. If you have some woofer
mounting flexibility, keep the followiing in mind:
Lower mounting locations, such as the lower front
corner of a door or a kick-panel provide the
greatest path length distances for the sound emitted
by the woofer. For this reason, they are generally
more desirable than higher mounting locations.
Higher mounting locations will usually result in
extreme near-side soundstage bias which
compromises the stereo listening experience.
JL AUDIO TR650-CSi 3
Less Desirable More Desirable
Less Desirable More Desirable
TR650-CSi SPECIFICATIONS:
Woofers: Injection-molded, mica-filled, polypropylene
cone body, 1-inch (25mm) voice coil, flat-profile/
symmetrical-roll spider, butyl rubber surround.
Tweeters: 0.50-inch (12 mm) textile dome
diaphragm, integral phase plug, neodymium magnet,
ferrofluid cooled and damped. Designed for flush
or surface mounting.
Crossover Design: Natural roll-off low pass
(woofer), 1st order high-pass circuit with electrolytic
capacitor on tweeter. Polyswitch tweeter protection.
Continuous Power Handling:
50 Watts (RMS Method)
Recommended Amplifier Power:
10-75 Watts per channel (RMS Method)
Frequency Response: 59 Hz - 22 KHz (± 3 dB)
Efficiency @ 1W/1m: 91.0 dB
Nominal Impedance: 4 ohms
Included Components and Parts:
• Two TR650-CWi 6.5-inch (160 mm) Woofers
• Two TR050-CT 0.50-inch (12 mm) Tweeters
• Two TR050-CThp In-Line, High-Pass Filters on
5.3 ft. (1.6 m) Wire Harnesses
• Two Metal Spring Clips (for tweeter
flush mounting)
• Two Surface-Mount Tweeter Fixtures
• Two Metal Woofer Grilles and Grille Trays
• Butyl Adhesive Putty (for woofer grilles)
• Eight #8 x 1 1/4-inch (30 mm)
Sheet Metal Screws
• Four #6 x 5/8” (16 mm) Sheet Metal Screws
• Two 1/4-inch (6 mm) Machine Screws
• Eight Mounting Clips (for woofer mounting)
• Two 5.2 mm Female Crimpable Connectors
• Two 2.8 mm Female Crimpable Connectors
GETTING STARTED:
• Turn off the audio system. It is also advisable to
disconnect the negative (-) terminal of your
vehicle’s battery whenever performing
installation work.
• Before cutting, drilling or inserting any screw,
check clearances on both sides of the planned
mounting surface. Also check for any potential
obstacles, such as window tracks and motors,
wiring harnesses, etc. Check both sides of the car,
many cars are not symmetrical!
• Always wear protective eyewear.
It is absolutely vital that your component
system is connected as shown in the diagram
below. Failure to connect the system as shown
will result in damage to your speakers which is
NOT covered under warranty. Do not substitute
different crossover networks or filters into your
TR650-CSi System. Only use in-line filters clearly
marked “TR050-CThp”.
WA RN I NG
!!
2 JL AUDIO TR650-CSi
A) Wiring Diagram:
INSTALLING THE WOOFERS IN
CUSTOM LOCATIONS:
Run speaker wire to the desired mounting
location. If you are running wires into a door, use
existing factory wiring boots whenever possible. If
you are drilling new holes, file their edges and install
rubber grommets into each hole. Then, cover the
wires with a protective PVC sleeve and run them
through the door jamb. Make sure that the wires
will clear door hinges and other structures in the
door. If you are unsure about any part of this
process, please contact your JL AUDIO dealer for
installation help.
Double check the clearance for both speakers
before proceeding.
Use the supplied template on the top of the
product packaging to mark the desired mounting
location. Mark the center and the outline of the
mounting hole as well as the mounting screw
positions. Before drilling or cutting, use a utility knife
to cut any fabric, vinyl or leather from hole
locations. These materials can easily be snagged by
a drill or a saw, causing damage to the panel and
possible bodily injury.
Drill four 1/8" (3 mm) holes for the speaker’s
mounting screws at the positions you have marked.
Also drill a pilot hole in the center of the speaker
mounting hole at this time. Then, using a saber saw,
hole saw or nibbler, make the circular cut out for
the speaker. File any rough edges.
Insert the mounting clips with the flat side
towards the speaker as shown in the diagram.
It is absolutely vital that the speaker frame fits
into the mounting hole cleanly. This must be
checked prior to tightening the screws. Do not
force the frame into a hole that is too small! Do
not tighten the speaker onto an uneven surface! This
will damage your speakers. The speaker should also
fit so that no air leaks around the mounting flange.
Air leaks will cause a severe degradation in sound
quality. Seal any air leaks with silicone, rope caulk or
similar sealant material.
Connect the speaker wires, observing correct
polarity, and install the speaker and grille tray as
shown.
Hand-tighten the screws evenly to avoid
bending the speaker frame!
Break off small pieces of the supplied butyl
adhesive putty and place them on the inside of each
grille tray. This adhesive will hold the grille in place
firmly and prevent rattling. Then insert the metal
grille into the grille tray, squeezing gently around its
edge until it seats firmly into the tray.
JL AUDIO TR650-CSi 5
INSTALLING THE WOOFERS IN
FACTORY LOCATIONS:
If you will be using the factory speaker wires, it
may be necessary to change the terminations. This
may be accomplished by using an adaptor plug or
simply by cutting the factory connector off and
using the supplied crimp connectors to terminate
the speaker wires.The large connector is for the
positive terminal and the small connector is for the
negative terminal of each woofer. Make sure that
you observe correct polarity in your connections. If
you are unsure about any of these issues, contact
your JL AUDIO dealer for installation assistance.
Your new speakers have been designed to install,
without modifications, into most vehicles that accept
a 6.5-inch (160 mm) speaker. Most factory 6.5-inch
speakers use four mounting screws which will line
up with the mounting holes on your woofers.
Others use a 3-hole mounting system which is
accommodated by a separate set of mounting holes
on the frames of your TR650-CWi woofers.
It is absolutely vital that the speaker frame fits
into the mounting hole cleanly. This must be
checked prior to tightening the screws. Do not
force the frame into a hole that is too small! Do
not tighten the speaker onto an uneven surface! This
will damage your speakers. The speaker should also
fit so that no air leaks around the mounting flange.
Air leaks will cause a severe degradation in sound
quality. Seal any air leaks with silicone, rope caulk or
similar sealant material.
Install as shown in the diagram here.
Use the supplied mounting clips unless the
factory holes already feature threaded inserts.
Hand-tighten the screws evenly to avoid bending
the speaker frame!
4 JL AUDIO TR650-CSi

Termékspecifikációk

Márka: JL Audio
Kategória: hangszóró
Modell: Evolution TR650-CSi

Szüksége van segítségre?

Ha segítségre van szüksége JL Audio Evolution TR650-CSi, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók hangszóró JL Audio

JL Audio

JL Audio C1-690tx Útmutató

7 Október 2024
JL Audio

JL Audio C5-525x Útmutató

20 Szeptember 2024
JL Audio

JL Audio C5-570 Útmutató

19 Szeptember 2024
JL Audio

JL Audio M3-770X Útmutató

17 Szeptember 2024
JL Audio

JL Audio Evolution C2-570x Útmutató

14 Szeptember 2024
JL Audio

JL Audio M103EWS-CG-WH-L Útmutató

13 Szeptember 2024
JL Audio

JL Audio C6-100ct Útmutató

30 Augusztus 2024
JL Audio

JL Audio C6-650 Útmutató

30 Augusztus 2024
JL Audio

JL Audio CF-350mt Útmutató

30 Augusztus 2024
JL Audio

JL Audio C6-650cw Útmutató

30 Augusztus 2024

Útmutatók hangszóró

Legújabb útmutatók hangszóró

QSC

QSC MD-FP152-124r Útmutató

30 Március 2025
QSC

QSC PL-CA6 Útmutató

30 Március 2025
QSC

QSC PL-SUB15 Útmutató

30 Március 2025
QSC

QSC PL-SUB10 Útmutató

30 Március 2025
QSC

QSC MD-FP152-64r Útmutató

30 Március 2025
QSC

QSC PL-SUB12 Útmutató

30 Március 2025
Audac

Audac ARCHI210 Útmutató

30 Március 2025
Audac

Audac ARCHI10 Útmutató

30 Március 2025
Prixton

Prixton Jaia Útmutató

30 Március 2025
Prixton

Prixton Jaia Max Útmutató

30 Március 2025