Használati útmutató Indesit DCF1A 250 UK.1

Indesit mélyhűtő DCF1A 250 UK.1

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Indesit DCF1A 250 UK.1 (4 oldal) a mélyhűtő kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/4
INSTRUCTIONS FOR USE
EN
DIAGRAM OF THE APPLIANCE (Fig. 1)
A. Handle.
B. Safety lock (if provided).
C. Gasket.
D. Separator (if provided).
E. Defrost water drain plug.
F. Control panel.
G. Side motor cooling grille.
DIAGRAM OF THE CONTROL PANEL (Fig. 2)
1. Temperature adjustment thermostat.
2. Red light (if provided): indicates that the temperature
inside the product is not low enough.
3. Green LED (if provided): when lit, indicates that the
appliance is running.
4. : Yellow/orange illuminated button (if provided)
activates/deactivates the fast freeze function.
When lit, it indicates that the fast freeze function is active.
The fast freeze function automatically deactivates after
about 50 hours.
The exact conguration of the control panel may vary
according to the model.
INSTALLATION
• Unpack the appliance.
• Remove the 4 spacers inserted between the door
and the appliance. (Fig 3)
• Make sure the defrost water drain plug (if provided) is
correctly positioned (E).
• For optimum appliance operation and to avoid damage
when the door is opened, leave a space of at least 7 cm
from the rear wall and 7 cm at the sides. (Fig. 4)
• Fit the accessories (if provided).
• Clean the inside of the appliance before using it.
SWITCHING ON THE APPLIANCE
• The appliance is factory set for optimum operation at a
temperature of -18°C.
• Plug in the appliance.
• The green LED lights up (if provided).
• Also the red LED (if provided) will switch on because
the temperature inside the appliance is not yet
suciently low for food storage. The red LED will
normally switch o within the rst six hours after the
appliance is switched on.
• After connecting the appliance to the mains supply
and when the optimal temperature has been reached,
ensure that the fast freeze button is not pressed (the
yellow LED, if provided, is o).
• Place food inside the product only when the red LED
(if provided) has switched o.
Note: As the seal is tight, the appliance lid cannot be
reopened immediately after closing. Wait a few minutes
before re-opening the lid of the appliance.
This appliance features “skin condenser” technology:
the condensing unit is integrated into the walls of
the freezer. For this reason the side and front walls
of the product may become hot while the product
is running. This is entirely normal and also reduces
the risk of condensation forming in particularly
critical environmental conditions (see paragraph
“Troubleshooting guide”).
TEMPERATURE ADJUSTMENT
Use the thermostat to select the ideal storage temperature.
To adjust the internal temperature, proceed as follows:
• Turn the thermostat knob to 1 for a storage temperature
that is less cold.
• Turn the thermostat knob to 6 for a colder storage
temperature.
• For partial loads, or when the load indicator is below
the “e” symbol inside the appliance (if present), it is
advisable to move the thermostat to the lower position
(on “e”, if present on the thermostat scale)
FREEZING FOOD
Preparation of fresh food for freezing
• Before freezing, wrap and seal fresh food in: aluminium
foil, cling lm, air and water-tight plastic bags,
polyethylene containers with lids, provided they are
suitable for freezing foods.
• Food must be fresh, mature and of prime quality in order
to obtain high quality frozen food.
• Fresh vegetables and fruit should preferably be frozen
as soon as they are picked to maintain the full original
nutritional value, consistency, colour and avour.
• Always leave hot food to cool before placing in the
appliance.
Freezing fresh food
• Place foods to be frozen in direct contact with the walls
of appliance (Fig. 5):
A) - foods to be frozen,
B) - foods already frozen.
• Avoid placing foods to be frozen in direct contact with
food already frozen.
• For best and fastest freezing, foods should be split into
small portions; this will also be useful when the frozen
items are to be used.
1. At least 24 hours before storing fresh food in the
appliance, press the fast freeze button (4).
2. Place the food to be frozen and keep the lid of the
appliance closed for 24 hours. The fast freeze function
automatically deactivates after about 50 hours.
FOOD STORAGE
Refer to the table on the appliance.
Classication of frozen foods
Load and classify the frozen foods; it is advisable
to indicate the storage date on the packs, to ensure
consumption before the expiry dates listed in months in
Fig. 6 for each type of food.
Advice for storing frozen food
When buying frozen food, make sure that:
• The packaging is intact (food in damaged containers
may have deteriorated). If a package is swollen or has
damp patches, the product may not have been stored
in optimum conditions and therefore undergone partial
defrosting.
• When shopping, leave frozen food purchases until last
and carry them in a thermally insulated bag.
• On arriving home, immediately place the frozen food in
the appliance.
• Avoid or minimise temperature variations. Observe the
expiry date on the packaging.
• Always follow the storage instructions on frozen food
packages.
Note:
• Eat fully or partially defrosted foods immediately.
Do not refreeze unless the food is cooked after it
has thawed. Once cooked, the food can be refrozen.
• In case of a prolonged power failure: Do not open
the appliance door, except to place ice packs (if
provided) over the frozen foods on the right and left
side of the appliance. This will slow down the rise in
temperature.
APPLIANCE DEFROSTING
The appliance should be defrosted when the thickness of
ice on the walls reaches 5-6 mm.
• Disconnect the appliance from the power supply.
• Remove food from the appliance and put it in a very
cool place or a thermally insulated bag.
• Leave the appliance door open.
• Remove the internal defrost water drain plug (depending
on model) (Fig. 8).
• Remove the external defrost water drain plug
(depending on model) and reposition it as shown in
g. 8.
• Use the separator (depending on model) inside the
product as a recipient for any remaining water, (D) as
shown in g. 8. If there is no separator, use a shallow
container.
• Defrosting can be sped up by using a spatula to detach
the frost from the appliance walls.
• Remove the frost from the bottom of the appliance.
• In order to avoid permanent damage to the
appliance interior, do not use pointed or sharp
metal instruments to remove the ice.
• Do not use abrasive products or heat up the
interior articially.
• Dry the inside of the appliance thoroughly.
• Ret the plug after defrosting.
HANGING THE LID LIGHT BULB (if provided)
• Disconnect the appliance from the mains power supply.
• Remove the diuser by following the sequence of steps
shown in the gure.
• Unscrew the light bulb and replace it with an identical
bulb of the same wattage and voltage.
• Ret the diuser and plug in the appliance.
TROUBLESHOOTING GUIDE
1. The red LED (if provided) remains alight.
• Is there a power failure?
• Is defrosting in progress?
• Is the appliance lid properly closed?
• Is the appliance positioned near a heat source?
• Is the thermostat setting correct?
• Are the ventilation grille and condenser clean?
2. The appliance is too noisy.
• Is the appliance perfectly horizontal?
• Is the appliance in contact with other furniture or objects
that may cause vibrations?
• Has the packaging been removed from under the
appliance?
Note: Gurgling noises from the refrigerating circuit after the
compressor cuts out are perfectly normal.
3. The green LED (if provided) is o and the
appliance is not working.
• Is there a power failure?
• Is the plug properly inserted in the socket?
• Is the electric cable intact?
4. The green LED (if provided) is o and the
appliance is working.
• The green LED is not working. Contact the After Sales
Service for a replacement.
5. The compressor runs continuously.
• Have hot foods been put in the appliance?
• Has the appliance lid been left open for a long time?
• Is the appliance positioned in a very warm room or near
heat sources?
• Is the thermostat setting correct?
• Has the fast freeze function (depending on model) been
pressed by mistake?
6. Too much ice on the upper edge.
• Are the defrost water drainage plugs correctly
positioned?
• Is the appliance lid properly closed?
• Is the appliance lid seal damaged or deformed? (See
chapter “Installation”)
• Have the 4 protection pieces been removed? (See
chapter “Installation”)
7. Condensation forms on the external walls of the
appliance
• It is normal for condensation to form under certain
atmospheric conditions (humidity above 85%) or if the
appliance is located in a damp or poorly ventilated
room.
The performance of the appliance is in no way aected.
8. The layer of ice on the internal walls of the
appliance is not uniform.
• This phenomenon is quite normal.
ELECTRICAL CONNECTION FOR GREAT BRITAIN AND
IRELAND ONLY
Warning – this appliance must be earthed.
Fuse replacement
If the mains lead of this appliance is tted with a BS 1363A
13amp fused plug, to change a fuse in this type of plug use
an A.S.T.A. approved fuse to BS 1362 type and proceed
as follows:
1. Remove the fuse cover (A) and fuse (B).
2. Fit replacement 13A fuse into fuse cover.
3. Ret both into plug.
Important:
The fuse cover must be retted when changing a fuse and
if the fuse cover is lost the plug must not be used until a
correct replacement is tted.
Correct replacement are identied by the colour insert or
the colour embossed in words on the base of the plug.
Replacement fuse covers are available from your local
electrical store.
For the Republic of Ireland only
The information given in respect of Great Britain will
frequently apply, but a third type of plug and socket is also
used, the 2-pin, side earth type.
Socket outlet / plug (valid for both countries)
If the tted plug is not suitable for your socket outlet, please
contact After-sales Service for further instruction.
Please do not attempt to change plug yourself. This
procedure needs to be carried out by a qualied technician
in compliance with the manufactures instructions and
current standard safety regulations.
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1. See if you can solve the problem yourself.
2. Switch the appliance on again to see if the problem
has been solved. If it has not, disconnect the appliance
from the power supply and wait for about an hour before
switching on again.
3. If the problem persists after this course of action, contact
After-Sales Service.
Specify:
• the nature of the fault,
• the model,
• the service number (the number after the word SERVICE
on the rating plate on the rear of the appliance),
• your full address,
• your telephone number and area code.

Termékspecifikációk

Márka: Indesit
Kategória: mélyhűtő
Modell: DCF1A 250 UK.1

Szüksége van segítségre?

Ha segítségre van szüksége Indesit DCF1A 250 UK.1, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók mélyhűtő Indesit

Indesit

Indesit LD85 F1 K Útmutató

14 Január 2025
Indesit

Indesit INC18D011B1 Útmutató

10 December 2024
Indesit

Indesit CAA 55 NF UK.1 Útmutató

7 Október 2024
Indesit

Indesit TFAA 10 SI (UK).1 Útmutató

6 Október 2024
Indesit

Indesit SIAA 12 (UK) Útmutató

3 Október 2024
Indesit

Indesit IBC18 5050 F1 Útmutató

30 Szeptember 2024
Indesit

Indesit OS 1A 400 H Útmutató

29 Szeptember 2024
Indesit

Indesit SIAA 55 WD UK.1 Útmutató

23 Szeptember 2024
Indesit

Indesit LI8 S1E W UK Útmutató

21 Szeptember 2024
Indesit

Indesit TAN 5 L FNF (TK) Útmutató

19 Szeptember 2024

Útmutatók mélyhűtő

Legújabb útmutatók mélyhűtő

Miele

Miele F 2412 Vi Útmutató

10 Április 2025
Gram

Gram FSD 23 Útmutató

10 Április 2025
Gram

Gram KC 494186 FN/1 Útmutató

10 Április 2025
Midea

Midea MRC10M4CWW Útmutató

9 Április 2025
Miele

Miele FNS 4382 D N Útmutató

9 Április 2025
Swan

Swan SR11025GRN Útmutató

6 Április 2025
Summit

Summit ALFZ53CSS Útmutató

30 Március 2025
Accucold

Accucold FS407L Útmutató

29 Március 2025
LG

LG GC-164SQW Útmutató

22 Március 2025
Atag

Atag KU1090C Útmutató

19 Március 2025