Használati útmutató Hotpoint AQC9 BF7 E1 (UK)

Hotpoint Szárítógép AQC9 BF7 E1 (UK)

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Hotpoint AQC9 BF7 E1 (UK) (20 oldal) a Szárítógép kategóriában. Ezt az útmutatót 9 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF

Oldal 1/20

English

TUMBLE DRYER

AQUALTIS

AQC9 BF7

Instruction booklet

Contents

Installation, 2

Where to put your dryer

Ventilation

Electrical connection

Levelling the tumble dryer

Before you start using your dryer

Warnings and Suggestions, 4

General safety

Save energy and respect the

Environment

Maintenance and Care, 6

Switching off the electricity

Clean the filter after each cycle

Check the drum after each cycle

Empty the Water Container after each cycle

Cleaning the Heat Pump Filter

Cleaning the dryer

Dryer Description, 8

Open the door

The Features

Control Panel

The Display, 9

Start and Programmes, 10

Choosing a Programme

Special Programmes

Table of Programmes

The Controls

Laundry, 16

Sorting your laundry

Wash care labels

Drying times

Troubleshooting, 17

Service, 18

Spare parts

Disposal

! This symbol reminds you to read this

instruction manual.

! Keep this manual at hand for immediate reference whenever

necessary. Always store this manual close to the tumble dryer and

remember to pass it on to any new owners when selling or tran-

sferring the appliance, so they may familiarise with the warnings

and suggestions herein contained.

! Read these instructions carefully: the following pages contain

important information on installation and useful suggestions for

operating the appliance.

www.hotpoint.co.uk

To activate you free* 5 years parts guarantee

Call free on 0800 519 2102

*Labour charges not included. Terms and conditions apply. Lines open 364 days a year.

Calls are free from a BT landline. Charges from other providers and mobiles may apply.

Where to install the tumble dryer

• Install the dryer far

from gas ranges, stoves,

radiators or hobs, as

flames may damage it.

If the dryer is installed

below a worktop, en-

sure there are 10 mm

between the upper pa-

nel of the dryer and any

objects above it, and 15

mm between the sides of the machine and

the walls or furniture units adjacent to it. This

ensures adequate air circulation.The applian-

ce must be installed with the rear surface

placed against a wall.

Ventilation

• The room must be adequately ventilated while the dryer is

running. Make sure that the dryer is installed in a room free

of humidity and with adequate air circulation. The flow of air

around the dryer is essential to allow water to condense du-

ring drying; the dryer will not function properly if it is placed

in an enclosed space or inside a cabinet.

! Some condensation may form if the dryer is used in a small

or cold room.

! We do not recommend that the dryer is installed in a

cupboard but the dryer must never be installed behind a

lockable door, a sliding door or a door with a hinge on the

opposite side to that of the dryer door.

We do not recommend that the dryer is

installed in a cupboard but the dryer must never

be installed behind a lockable door, a sliding

door or a door with a hinge on the opposite

side to that of the dryer door.

Water drain

If your dryer is installed next to a drain the water can be

plumbed into this drain. This does away with the need to

empty the water container. If the dryer is stacked onto or

installed next to a washing machine it can share the same

drain. The height of the drain must be less than 3’ (1 m) from

the bottom of the dryer.

Remove existing hose from position shown in picture A and fit

a suitable length of hose and connect as shown in picture B.

! Make sure that the hose is not squashed or kinked

when the dryer is in its final location.

Electrical connections

Before plugging the appliance into the socket,

check the following:

• Make sure your hands are dry.

• The socket must have an earth connection.

• The socket must be able to withstand the

machine’s maximum power output as indi-

cated on the rating plate (see Description

of the tumble dryer).

• The power supply voltage must fall within

the values indicated on the data plate (see

Description of the tumble dryer).

• The socket must be compatible with the

dryer’s plug. Should this not be the case,

replace the plug or the socket.

! Do not use extension cords.

! The dryer must not be installed outdoors,

even if the space is sheltered. It can be very

dangerous if exposed to rain or storms.

! Once installed, the dryer’s electrical wire

and plug must be within reach.

! The power cord must not be bent or

squashed.

! The power cord is supplied fitted with a

BS1363 plug and with a 13 amp BS1362 fuse.

If it is necessary to fit a replacement fuse, it must

be a 13 Amp ASTA approved to BS1362 type.

WARNING: The plug must not be used without

a fuse cover. If a replacement fuse holder/cover

is required, it must be of the same colour coding

or wording as shown on the base of the plug.

Replacements are available from authorised

dealers.

Changing the plug

The wires in the power cord are coloured in

accordance with the following.

! If the plug being replaced is a non-

rewirable type, then the cut-off plug

must be disposed of safely. DO NOT

leave it where it can be inserted into a

socket and create a shock hazard.

! The power must be regularly che-

cked. If the supply cord is damaged, it

Less than 1m

Picture APicture B

Installation

10 mm

15 mm 15 mm

This household tumble drier is a Condenser

The weighted Annual Energy Consumption (AEc)* kWh 1) 615.8

This household tumble drier is a Automatic

Energy consumption full load; Edry - kWh 2) 5.19

Energy consumption partial load; Edry½ - kWh 2) 2.83

Power consumption: off-mode (Po) - Watts 0.14

Power consumption: left-on mode (Pl) - Watts 2.68

Prog. Time - weighted (Tt) full & partial load - minutes 3) 113

Full load (Tdry) - minutes 151

Partial load (Tdry½) - minutes 84

weighted (Ct) full & partial load 3) 83

full load (Cdry) 86

partial load (Cdry½) 81

Airborne acoustical noise emissions - dB(A) re 1 pW 69.0

Programme time in minute, for program “Synthetics” full load 65

Partial load for program “Synthetics” N/A

Average condensation efficiency - %

1) The "standard cotton” at full and partial load are the standard programmes to

which the information in the label and the fiche relates. The standard cotton

program is suitable to dry at cupboard level (0%) cotton laundry and is the most

efficient programme in terms of energy consumption. Partial load is half the rated

load.

2) based on 160 drying cycles of the standard cotton programme at full and partial

load, and the consumption of the low-power modes. Actual energy consumption

will depend on how the appliance is used.

3) Weighted average of 3 cycles at full load and 4 cycles at half load.

Regulation 932/2012.

Energy consumption in kWh, for program “Synthetics” full load 1.39

Energy efficiency class on a scale from A+++ (low consumption)

to D (high consumption) B

Duration of the 'left-on mode' for power management system -

minutes 30

Condensation efficiency class on a scale from G (least efficient) to

A (most efficient) B

Product Fiche - Regulation 392/2012.

Brand

HOTPOINT

Model

AQC9 BF7 I1(UK)

Rated capacity of cotton laundry for the "standard cotton

programme" at full load - kg 9.0

Moulded plug

GREEN &

YELLOW

BROWN

BLUE

13 amper fusee

CROSS-BAR

CORD GRIP

Green and Yellow (Earth)

wire to terminal marked

“E”, symbol x, or coloured

green and yellow.

Blue (Neutral) wire to

terminal marked ”N” or

coloured black.

13A ASTA approved fuse

to BS 1362.

Brown (live) wire to

teminal marked “L” or

coloured red.

must be replaced by the manufacturer,

its service agent or similarly qualified

persons in order to avoid a hazard.

(see Assistance). New or longer elec-

tric cords are supplied by authorised

dealers at a supplementary cost.

! The manufacturer denies any

responsibility should any of these rules

not be followed.

! If in doubt about any of the above

consult a qualified electrician.

Preliminary information

Once the tumble dryer is installed, clean the inside of the

drum before operating it and remove any dirt accumulated

during transportation.

Maximum load sizes: kg9

Termékspecifikációk

Márka:	Hotpoint
Kategória:	Szárítógép
Modell:	AQC9 BF7 E1 (UK)

Szüksége van segítségre?

Ha segítségre van szüksége Hotpoint AQC9 BF7 E1 (UK), tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek

Az Ön neve*

Az Ön e-mail címe*

Írja ide kérdését

Útmutatók Szárítógép Hotpoint

Hotpoint NWXR483GGWW Útmutató

14 Január 2025

Hotpoint NT M11 9X3E IT Útmutató

30 December 2025

Hotpoint NT M11 82XB IT Útmutató

15 December 2024

Hotpoint NT M11 8X3K IT Útmutató

15 December 2024

Hotpoint NT M11 9X3SKY IT Útmutató

15 December 2024

Hotpoint NT M11 82K IT Útmutató

15 December 2024

Hotpoint NTS M11 9X3E IT Útmutató

15 December 2024

Hotpoint NT M11 8X3SKY IT Útmutató

15 December 2024

Hotpoint NT M11 92WK IT Útmutató

15 December 2024

Hotpoint EU NTDG92 SK IT Útmutató

14 December 2024

Útmutatók Szárítógép

Legújabb útmutatók Szárítógép

Bauknecht traa prestige Útmutató

10 Április 2025

Bauknecht TRK 9876 Útmutató

10 Április 2025

Asko TH208HW Útmutató

10 Április 2025

Zanussi ZTA 245 Útmutató

9 Április 2025

Bauknecht TKL M11 72 Útmutató

9 Április 2025

Amana NGD4600YQ Útmutató

9 Április 2025

Whirlpool awz 9479 Útmutató

9 Április 2025

AEG 65770IH3 Útmutató

7 Április 2025

Arçelik 901 KMP IG Útmutató

7 Április 2025

Arçelik 901 KMP I Útmutató

7 Április 2025