Használati útmutató Hobbywing QUICRUN 3650 SD G2

Hobbywing Rádióvezérlésű játékok QUICRUN 3650 SD G2

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Hobbywing QUICRUN 3650 SD G2 (1 oldal) a Rádióvezérlésű játékok kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/1
USER MANUAL
QUICRUN 3650SD G2
Sensored Brushless Motor
This product is NOT a toy and it is for use by adults and teens over 14 only, so please keep it out of children’s
reach. Please keep the following points in mind; otherwise it may damage the product and cause property
loss and physical injuries to users.
• Never leave this product unsupervised when it is powered on. If any problem occurs, the product may cause a fire
and jeopardize peripheral devices.
• Please check wire sequences between the ESC & the motor carefully before the connection, to avoid any possible mistakes.
• Please insure all the wires and interconnecting pieces are well insulated before the connection, as short circuits may
damage the product.
• Never allow water, oil, fuel or other conducting liquids to get inside this product or other electronic parts, as these
liquids may contain harmful minerals for electrical circuits. If that really happens, please turn off the device
immediately, and then clear and blow-dry it carefully.
• Please read through manuals of each power equipment (like ESC, motor, battery, etc) and chassis to ensure the
power system configuration is rational before the use, as the incorrect power system configuration may result in
overload and eventually damage the equipments.
• Prohibit the full throttle operation before the pinion installation. Under non-loaded circumstances, over-high RPM
may cause damage to the motor.
• Make sure all the parts are well connected, as misconnection or poor connection may lead to abnormal control,
damage or other unpredictable problems.
• Never let the temperature of the motor can (shell) exceeds 90°C (194°F), otherwise the motor is likely to be
damaged and (or) the rotor will be demagnetized.
Safety Notes
CA UT IONS
Thank you for purchasing the “QUICRUN 3650 SENSORED G2” brushless motor(s) for RC
cars! The high power system can be very dangerous, so please read this manual carefully
before using and follow the operating procedures strictly. In that we have no control over the
installation, use and maintenance of this product, no liability shall be assumed nor accepted
for damages, losses or costs resulting from the use of this product. Besides, we own the right
to change the product design, appearance, functions and operational requirements without
any notifications.
AT T ENT ION
AT T ENT ION
01
03
Specifications
02
Installation & Connection
04
Gear Selection (IMPORTANT!)
05
Maintenance
It is very important to select the reasonable gear ratio, as inappropriate selection may cause great loss to users. Please select the correct gear ratio according to the following points!
1. Operating Temperature of the Motor
During the operation, the motor temperature should be lower than 90 (194 ). Temperatures above 90 will demagnetize the magnet & may melt the coils and eventually damage the ESC (because of strong current). Therefore, the most ℃ ℉ ℃
effective way to prevent over-heat is to select the right gear ratio.
2. Principle of Gear Selection
To avoid potential risks, caused by overheating, which may lead to ESC/motor damage or malfunction, please start with very small pinion and check ESC & motor temperatures frequently throughout a run. This is the only way to guarantee
that you are not causing excessive heating. If Motor and the ESC temperatures remain stable and low in the running, then you can slowly increase the pinion (with more teeth) while again monitoring the temperatures to determine the safe
gearing for your vehicle and motor. Because the climate and track conditions always change, please keep monitoring ESC & motor temperatures to protect your electronics from damage.
Vehicle Type Battery 10.5T 13.5T 17.5T 21.5T 25.5T
3.2:1
2.7:1
66mm
5.2:1
5.2:1
Touring Car (for Small track) 7.4V LiPo 5.5:1 4.7:1 4.0:1 3.5:1
Touring Car (for Big track) 7.4V LiPo 5.0:1 4.0:1 3.5:1 3.0:1
1/12 Touring Car 3.7V LiPo 42mm 51mm 66mm 66mm
2WD Buggy 7.4V LiPo 8.0:1 7.0:1 6.0:1 5.5:1
4WD Buggy 7.4V LiPo 8.0:1
6.5T
8.0:1
7.0:1
35mm
10.3:1
10.8:1
8.5T
7.0:1
6.3:1
38mm
8.5:1
8.9:1 7.0:1 6.0:1 5.5:1
R2ZZ bearing, 3.175 x 9.525 x 3.967
Specification
1. To Install the Motor
Screws used for installation are 3mm in diameter & 5mm in length. Before mounting the motor onto the
vehicle, please ensure that all the screws are applicable to avoid damaging the motor. In general it’s ok to
adopt screws which are 3 mm in diameter and less than 7mm in length; the specific length is up to the
chassis size.
2. To Connect the Motor
1) Three power wires need to be connected to the motor, and they often differ in colors: Phase wire A is
Blue, Phase wire B is Yellow and Phase wire C is Orange. Please note the ESC mark while connecting ESC
output wires to motor power wires and ensure connections are: A-A, B-B and C-C.
2) If you are using a sensored ESC, please insure Hall-sensor wires are clean and undamaged; then connect
them in the correct direction to the sensor ports of the motor & the ESC respectively. Warning: In such a case,
thewire sequence of the ESC and the motor must strictly follow the rules of A-A, B-B and C-C. Do not
change the wires sequence.
3) While if the ESC is a sensorless one, then connect the motor and the ESC according to the above way may
cause the motor to rotate in the opposite direction, because definitions of phase (#A / #B / #C) are different
among manufacturers, at this time you only need to swap any of two wire connections.
3. Checkup
Recheck the installation and all the connections carefully before turning on the power.
For prolonging the motor life and raising its efficiency, we recommend users to check the bearing, and clean the motor regularly; and the specific interval depends on the usage frequency and terrains. Please follow the assembly diagram
below to assemble the motor, and disassemble in reserve order.
540 MOTOR BEARING-3.175 R2ZZ bearing, 3.175 x 9.525 x 3.967mm
Replaceable Part Part No. Product Name Specification
Bearing 30820001
Optional Accessories
3. Gear Ratio(s) Suggested
The below form shows some rough data about gear ratios (these recommended ratios are reference
values when setting the ESC to the Zero Timing Mode). If you don’t know how to set the suitable gear
ratio, please begin with a big ratio (i.e. small pinion) and then adjust as required, or consult with on-site
drivers who are using the same power unit for basic information.
Model PN KV
(No-load)
No-load
Current
Dimension
(mm)
shaft *
(mm) Pole ApplicableLiPo W (g)
R. (Ω)
2~3S
2S
Outer
Diameter
36
Length
52.8
2
Diameter
3.17
Length of
Projectiong part
15
1:10 ,1:12 On-Road (Truggy / F1 / Monster) &
Off-Road (Buggy / 2WD SC Truck / Truck)
STOCK / SPORT Race (choose the motor base
on competition rules.) Free / casual run for new
beginners. Rock Crawler (21.5T 25.5T only)/
30404312
30404311
30404309
30404310
30404306
30404307
30404308
5750
4560
3600
2850
2170
1800
1520
0.0066
0.0125
0.0183
0.0289
0.0488
0.0747
0.1
4.6
3.2
2.8
2.4
1.6
1.3
1.1
194
186
186
186
187
187
186
QUICRUN-3650SD-6.5T-G2
QUICRUN-3650SD-8.5T-G2
QUICRUN-3650SD-10.5T-G2
QUICRUN-3650SD-13.5T-G2
QUICRUN-3650SD-17.5T-G2
QUICRUN-3650SD-21.5T-G2
QUICRUN-3650SD-25.5T-G2
The back end bell Motor rotor
Dirt-proof silicon ring Screws for fixing the motor Picture of the finished product
1
2 4
3 5
6, Screws for fixing the motor
Screws for Fixing
the Motor x 3pcs
(M2.50x47.8mm)
Motor Rotor x1pcs
Outer Shell x1pcs
(with Front End Bell)
Dirt-proof Silicon
Ring x1psc
Back End Bell x1pcs
Sensor port of motor
Sensor wire
20160914

Termékspecifikációk

Márka: Hobbywing
Kategória: Rádióvezérlésű játékok
Modell: QUICRUN 3650 SD G2

Szüksége van segítségre?

Ha segítségre van szüksége Hobbywing QUICRUN 3650 SD G2, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Rádióvezérlésű játékok Hobbywing

Hobbywing

Hobbywing XeRun XR10 Pro WP Útmutató

25 Szeptember 2024
Hobbywing

Hobbywing XeRun XR10 Stock Spec G2 Útmutató

25 Szeptember 2024
Hobbywing

Hobbywing XeRun XR10 Justock G3S Útmutató

25 Szeptember 2024
Hobbywing

Hobbywing XeRun XR8 PRO G3 Útmutató

25 Szeptember 2024
Hobbywing

Hobbywing XeRun XR10 Justock G3 Handout Útmutató

25 Szeptember 2024
Hobbywing

Hobbywing XeRun XR8 Plus G2S Útmutató

25 Szeptember 2024
Hobbywing

Hobbywing XeRun XR10 Pro 1S Heavy Duty Útmutató

25 Szeptember 2024
Hobbywing

Hobbywing XeRun XR10 Stock Spec 1S Útmutató

25 Szeptember 2024
Hobbywing

Hobbywing XeRun XR10 PRO 160A Útmutató

25 Szeptember 2024
Hobbywing

Hobbywing Xerun V10 G3 Útmutató

3 Szeptember 2024

Útmutatók Rádióvezérlésű játékok

Legújabb útmutatók Rádióvezérlésű játékok

Reely

Reely JoVage 4x4 V2 Útmutató

12 December 2024
MJX

MJX Hyper GO Útmutató

12 December 2024
Amewi

Amewi MEW4 Útmutató

11 December 2024
Spektrum

Spektrum AR6600T Útmutató

15 Október 2024
Little Tikes

Little Tikes Tire Twister Útmutató

8 Október 2024
Futaba

Futaba 12Z Útmutató

4 Október 2024
Graupner

Graupner 33718.XT60 Útmutató

3 Október 2024
Proline

Proline Trencher Útmutató

3 Október 2024
Amewi

Amewi Hyper Go Útmutató

1 Október 2024
Carson

Carson Drift Burner Útmutató

1 Október 2024