Használati útmutató Hikvision DS-2CE16C8T-IW3Z

Hikvision Térfigyelő kamera DS-2CE16C8T-IW3Z

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Hikvision DS-2CE16C8T-IW3Z (4 oldal) a Térfigyelő kamera kategóriában. Ezt az útmutatót 10 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/4
TURBO HD
HLC HD Bullet Camera
User Manual
Regulatory Information
FCC Information
FCC compliance: This equipment has been
tested and found to comply with the limits for a
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference when the equipment is operated in
a commercial environment. This equipment
generates, uses, and can radiate radio
frequency energy and, if not installed and used
in accordance with the instruction manual, may
cause harmful interference to radio
communications. Operation of this equipment in
a residential area is likely to cause harmful
interference in which case the user will be
required to correct the interference at his own
expense.
FCC Conditions
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.
EU Conformity Statement
upon the purchase of equivalent new equipment,
or dispose of it at designated collection points.
For more information see: www.recyclethis.info.
2006/66/EC (battery directive):This
product contains a battery that cannot
be disposed of as unsorted municipal
waste in the European Union.
See the product documentation for specific
battery information. The battery is marked with
this symbol, which may include lettering to
indicate cadmium (Cd), lead (Pb), or mercury (Hg).
For proper recycling, return the battery to your
supplier or to a designated collection point. For
more information see: www.recyclethis.info.
U D.6L0201D2020A01
2012/19/EU (WEEE directive):
Products marked with this symbol
cannot be disposed of as unsorted
municipal waste in the European
Union. For proper recycling, return
this product to your local supplier
This product and - if applicable - the
supplied accessories too are marked
with "C E" and comply therefore with
the applicable harmonized European
standards listed under the Low Voltage Directive
2006/95/EC, the EMC Directive 2004/108/EC,
the RoHS Directive 2011/65/EU.
This series of camera adopts new generation
sensor with high sensitivity and advanced circuit
design technology It features high resolution,.
low image distortion and low noise, etc , which.
makes it suitable for surveillance system and
image processing system.
lHigh performance 1.37MP CMOS sensor and
high resolution bring high-quality image
OSD menu, parameters are configurable
l
lWhite Light Compensation
l 3D NR
lAuto white balance, auto gain control
lIP 66
1 Introduction
1.1 Product Features
1.2 Overview
Thank you for purchasing our product. If there
are any questions, or requests, please do not
hesitate to contact the dealer.
This manual applies to DS-2CE16C8T-IW3Z
model HLC HD bullet camera.
This manual may contain several technical
incorrect places or printing errors, and the
content is subject to change without notice.
The updates will be added to the new version of
this manual. We will readily improve or update
the products or procedures described in the
manual.
0200001050728
Please refer to the product specification for
camera parameters and functions.
Privacy Notice
Surveillance laws vary by jurisdiction. Check
all relevant laws in your jurisdiction before using
this product for surveillance purposes to ensure
that your use of this product conforms.
Industry Canada ICES-003 Compliance
.
This device meets the CAN ICES-3 (A)/NMB-3(A)
standards requirements.
1.2.1 Overview of HLC Bullet Camera
Figure 1-1 Overview of Bullet Camera
Make sure that the wall is strong enough to
withstand at least 4 times the weight of the
camera and the bracket.
2 Installation
Before you start:
l Please make sure that the device in the package
is in good condition and all the assembly parts
are included.
l Make sure that all the related equipment is
power-off during the installation.
l Check the specification of the products for the
installation environment.
l Check whether the power supply is matched
with your power output to avoid damage.
l If the product does not function properly,
please contact your dealer or the nearest
service center. Do not disassemble the camera
for repair or maintenance by yourself.
White Light Compensation
Sun Shield
CVBS Cable
Power Cable
HD Video Cable
Photosensitive Resistor
Motorized Lens
2.1 Wall Mounting
Steps:
1.Depart the tiltable bracket module from the
bracket, as shown in Figure 2-1.
Figure 2-1 Depart the Tiltable Bracket Module
Tiltable Bracket Module
2.Fix the bracket onto the wall with M6 expansion
screws, as sown in the figure 2-2.
Figure 2-2 Fix the Bracket onto the Wall
3 Menu Operation
Figure 3-1 Main Menu
VIDEO SETTING
BRIGHTNESS
EXPOSURE MODE
AGC
SHUTTER
SATURATION
3D NR
AUTO
MANUAL
MOTION
PRIVACY
D-ZOOM
LIGHT
COMPENSATION
CONTRAST
SHARPNESS
MIRROR
You can call the menu and adjust the camera
parameters with the direction button or a coaxial
camera controller (purchase separately). You can
also call the menu with supported DVR.
3.1 VIDEO.OUT
PAL or NTSC is selectable .
3.2 LAN GUAGE
Chinese and English are selectable.
3.3.2 EXPOSURE
EXPOSURE
1. BRIGHTNESS ---|------10
2. EXPOSURE HLC
3. AGC HIGH
4. SHUTTER OFF
Figure 3-2 Exposure
Move the cursor to EX PO SUR E and confirm to enter
the exposure setting interface. You can set the value
of brightness, select the exposure mode, AGC and
enable/disable the shutter.
BRIGHT NESS: You can set the brightness value
from 1 to 10.
Global and HLC mode are selectable.EXPOSURE:
: You can set the A GC as High, Middle, and Low.AGC
: The default value is 1/100. You can setSHUTT ER
a higher shutter value as to improve the image
quality when the vehicle speed is very high.
3.3.3 White Balance (W B)
Move the cursor to White Balance and press left/
right direction key to select the white balance mode
as Manual and Auto.
Select manual mode and enter the white balance
setting interface. You can adjust the value of Red
and Blue.
3.3.4 VIDEO SET TIN GS
Move the cursor to Video Settings and confirm to
enter the video setting interface.
VIDEO SETTING
1. CONTRAST 5
2. SHARPNESS 8
3. SATURATION 6
4. 3D NR OFF
5. MIRROR OFF
6. RETURN 8
Figure 3-5 Special
MOTION
1. SENSITIVITY HIGH
2. AREA 0 8
3. AREA 1 8
4. AREA 2 8
5. AREA 3 8
6. RETURN 8
Figure 3-6 Motion Detection
Motion: Select a MOT IO N area. Set the sensitivity
level as high, middle. or low.
Four areas are selectable for setting the motion
detection.
Privacy: Move the cursor to Privacy and confirm to
enter the video setting interface. You can select the
privacy color as mosaic, white, yellow, green, and
other colors. Up to eight areas can be set.
3.3.8 RESE T
Reset all the settings to the default.
3.3.9 EXIT
Press to exit the menu.OK
Mirror: Central, Vertical, Horizontal, and OF F are
selectable.
Figure 2-3 Attach the Tiltable Bracket Module
4.Route the cables to the cable hole and connect
the corresponding cables.
5.Fix the camera and the tiltable bracket module
to the bracket.
3. Attach the tiltable bracket module to the camera
with the supplied 1/4-20UN C screws.
Figure 2-4 Fix the Camera to the Bracket
6. Adjust the viewing angle.
1). Loosen P-Direction adjusting screw to adjust
the pan position (0 ~ 360 ).° °
2). Loosen T-Direction adjusting screw to adjust
the tilting position(0 ~ 90 ).° °
T-Direction Adjusting Screw
P-Direction Adjusting Screw
Figure 2-5 Image Adjustment
3.3.1 FOCUS
1. Enter the focus interface and adjust the camera
towards the scene.
MANUAL
1. RED 5
2. BLUE 4
3. RETURN
Figure 3-3 White Balance
Figure 3-4 Video Settings
2. Move the cursor to F OC U S+ (-) and click to focus,
and move the cursor to Z OO M+(-) and click to
zoom in and out.
3. After adjusting the camera lens, click Iris+ to save
the settings and exit the focus interface. 3.3.5 SPECIAL
Move the cursor to Special and confirm to enter
the video setting interface. You can set the motion
detection, privacy mask, digital zoom, and light
compensation, as shown in the figure 3-5.
SPECIAL
1. Motion 8
2. Privacy Mask 8
3. D-Zoom --|------ 20
4. Light OFF
5. RETURN 8
Contrast: Adjust the contrast from 1 to 10.
: Adjust the sharpness from 1 to 10.Sharpness
: Adjust the saturation from 1 to 10.Saturation
: Select the 3D NR level from high, middle,3D N R
and low.
3.3.6 DIG ITAL ZOOM
Move the cursor to D-Zoom and s et the zoom ratio
by pressing left/right direction keys. The zoom ratio
range varies from 50 to 100.
3.3.7 LIGH T C OMPE NSATION
Move the cursor to Light Compensation and set the
light mode as ON, OFF, or AU TO.
The light compensation level can be set from 1 to 5.
3.3 SE T UP
2.2 Pendent Mounting
1. Attach the pole bracket to the pole with the
supplied M6*20_3pcs screws.
Figure 2-6 Fix the Bracket onto the Pole
2. Attach the camera to the pole with the supplied
1/4-20UNC screws.
Steps:
Figure 2-7 Attach the Bracket to the Camera
3. Adjust the viewing angle.
1). Loosen P-Direction adjusting screw to adjust
the pan position (0 ~ 360 ).° °
2). Loosen T-Direction adjusting screw to adjust
the tilting position(0 ~ 180 ).° °
Figure 2-8 Image Adjustment

Termékspecifikációk

Márka: Hikvision
Kategória: Térfigyelő kamera
Modell: DS-2CE16C8T-IW3Z

Szüksége van segítségre?

Ha segítségre van szüksége Hikvision DS-2CE16C8T-IW3Z, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Térfigyelő kamera Hikvision

Hikvision

Hikvision DS-2CE10DF8T-FSLN Útmutató

6 Április 2025
Hikvision

Hikvision DS-2CE56C0T-IRPF Útmutató

5 Április 2025
Hikvision

Hikvision DS-2CD2141G1 Útmutató

5 Április 2025
Hikvision

Hikvision DS-2CE59U1T-AVPIT3ZF Útmutató

13 Január 2025
Hikvision

Hikvision IDS-2CD7526G0-IZHSY Útmutató

13 Január 2025
Hikvision

Hikvision DS-2CD2163G0-I(S) Útmutató

13 Január 2025
Hikvision

Hikvision DS-2CD2H83G1-IZS Útmutató

13 Január 2025
Hikvision

Hikvision DS-2CE16H0T-IT1E Útmutató

12 Január 2025
Hikvision

Hikvision THC-T127-PTLTS Útmutató

7 Január 2025
Hikvision

Hikvision DS-2CE16U0T-LF Útmutató

19 December 2024

Útmutatók Térfigyelő kamera

Legújabb útmutatók Térfigyelő kamera

Dahua Technology

Dahua Technology Pro IPC-HDPW5442G-Z Útmutató

15 Január 2025
Toshiba

Toshiba IKS-WR7412 Útmutató

14 Január 2025
Flir

Flir FC-610 O Útmutató

13 Január 2025
AVerMedia

AVerMedia FC1320-P Útmutató

13 Január 2025
Digitus

Digitus OptiMax DN-16037 Útmutató

13 Január 2025
ZKTeco

ZKTeco AntarVis 2.0 Útmutató

12 Január 2025
Speco Technologies

Speco Technologies O2P30X Útmutató

12 Január 2025
Kguard

Kguard QRT-501 Útmutató

12 Január 2025
Vivotek

Vivotek AI-108 Útmutató

12 Január 2025
Yale

Yale WIPC-303W Útmutató

12 Január 2025