Használati útmutató GE VTD56EASVWB

GE Szárítógép VTD56EASVWB

Olvassa el alább 📖 a magyar nyelvű használati útmutatót GE VTD56EASVWB (40 oldal) a Szárítógép kategóriában. Ezt az útmutatót 7 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/40
- Risk of Fire
• Clothes dryer installation must be performed by a
qualified installer.
• Install the clothes dryer according to these instructions
and local codes.
• DO NOT install a clothes dryer with flexible plastic venting
materials. If flexible metal (semi-rigid or foil-type) duct is
installed, it must be UL-listed and installed in accordance
with the instructions found in “Connecting the Dryer
to House Vent” later in this manual. Flexible venting
materials are known to collapse, be easily crushed and
trap lint. These conditions will obstruct dryer airflow and
increase the risk of fire.
• DO NOT install or store this appliance in any location
where it could be exposed to water or weather.
• To reduce the risk of severe injury or death, follow all
installation instructions.
• Save these instructions. (Installers: Be sure to leave
these instructions with the customer.)
In the Commonwealth of Massachusetts,
the following installation instructions apply:
• Installation must be performed by a qualified or
licensed contractor, plumber, or gasfitter qualified
or licensed by the State.
• If using a ball valve, it shall be a T-handle type.
• A flexible gas connector, when used, must not
exceed 4 feet.
FOR GAS DRYERS ONLY
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT – Save these instructions for local electrical
inspector’s use.
IMPORTANT –
Observe all governing codes and
ordinances.
• Install the clothes dryer according to the manufacturer’s
instructions and local codes.
• Note to Installer – Be sure to leave these instructions
with the Consumer.
• Note to Consumer – Keep these instructions for future
reference.
• Clothes dryer installation must be performed by a qualified
installer.
• This dryer must be exhausted to the outdoors.
• Before the old dryer is removed from service or discarded,
remove the dryer door.
• Do not allow children on or in the appliance. Close
supervision of children is necessary when the appliance
is used near children.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• Install the dryer where the temperature is above 50°F for
satisfactory operation of the dryer control system.
• Remove and discard existing plastic or metal foil duct
and replace with UL-listed duct.
• Service information and the wiring diagram are located
in the control console.
Questions? Call GE Appliances at 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.com
Dryers
Installation Instructions
WARNING
Failure to follow safety warnings exactly could
result in serious injury, death, or property damage.
- DO NOT store or use gasoline or other
flammable vapors and liquids in the vicinity of
this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
• DO NOT try to light any appliance.
• DO NOT touch any electrical switch; DO NOT
use any phone in your building.
• Clear the room, building, or area of any occupants.
•
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the
fire department.
- Installation and service must be performed by
a qualified installer, service agency, or the gas
supplier.
- Fire or Explosion
Hazard
WARNING
31-3000305 Rev 0 06-22 GEA
Installation Instructions
2
Tilt the dryer sideways and remove the foam
shipping pads by pulling at the sides and breaking
them away from the dryer legs. Be sure to remove
all of the foam pieces around the legs.
Remove the bag containing the literature.
UNPACKING YOUR DRYER
ROUGH-IN
DIMENSIONS
4 5/8”
(11.7 cm)
Y
X
4 1/4”
(10.8 cm)
Side View
Cubic
Foot X Y
7.4 43”
(109.2 cm)
30 1/2”
(78 cm)
7.4
(*with
Coin
Box
Kit)
45 7/8”
(116.5 cm)
30 1/2”
(78 cm)
*Coin Box Kit sold separately
X
27”
(68.8 cm)
Front View
ACCESSORIES:
Order on-line at , 24 hours a day or GEApplianceparts.com
by phone at during normal business hours.877.959.8688
Part Number Accessory
PM14X10056
Dryer door opening vent brush
WX14X10007
LintEater™ Dryer rotary tube brush
PM08X10085
Flexible Metal Dryer Transition Duct
TBDX10090 Coin Box Kit
Installation Instructions
MOBILE OR MANUFACTURED
HOME INSTALLATION
• Installation MUST conform to the MANUFACTURED
HOME CONSTRUCTION AND SAFETY
STANDARD, TITLE 24, PART 3280 or STANDARD
FOR MOBILE HOMES CAN/CSA-Z240 MH, or,
when such standards are not applicable, with
AMERICAN NATIONAL STANDARD FOR MOBILE
HOME, ANSI/NFPA NO. 501B.
• The dryer MUST be vented to the outdoors.
• The exhaust vent MUST be securely fastened to a
non-combustible portion of the mobile home.
• The vent MUST NOT be terminated beneath a
mobile or manufactured home.
• The vent duct material MUST BE METAL.
• KIT 14-D346-33 MUST be used to attach the dryer
securely to the structure.
• The vent MUST NOT be connected to any other
duct, vent or chimney.
• DO NOT use sheet metal screws or other
fastening devices which extend into the interior of
the exhaust vent.
• Provide an opening with a free area of at least 25
square inches for introduction of outside air into
the dryer room.
• See the sections for electrical connection information.
REQUIREMENTS FOR ALCOVE OR
CLOSET INSTALLATION
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18” (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
• The dryer MUST be vented to the outdoors.
• Minimum clearance between dryer cabinet and
adjacent walls or other surfaces is:
0” either side
0” rear
0” front
1” top
• Consideration must be given to provide adequate
clearance for installation and service.
• Closet doors must be louvered or otherwise ventilated
and have at least 60 square inches of open area. If
the closet contains both a washer and a dryer, doors
must contain a minimum of 120 square inches of
open area.
NOTE: WHEN THE EXHAUST DUCT IS LOCATED AT
THE REAR OF THE DRYER, THE CONFIGURATION
OF THE DUCTING MAY REQUIRE GREATER THAN
1” OF REAR CLEARANCE.
Gas Dryers Only:
• No other fuel burning appliance shall be installed in
the same closet as a gas dryer.
• The dryer must be disconnected from the gas
supply piping during pressure testing at pressures
greater than ½ psi (3.5 kPa).
• A 1/8 inch NPT minimum plugged tapping,
accessible for test gauge connection, must be
installed immediately upstream of the gas supply
connection to the dryer.
- Explosion Hazard
WARNING
MINIMUM CLEARANCE OTHER THAN
ALCOVE OR CLOSET INSTALLATION
Minimum clearance to combustible surfaces and
for air opening are: 0” both sides, 0” rear and 1” top.
Consideration must be given to provide adequate
clearance for installation and service.
3

Termékspecifikációk

Márka: GE
Kategória: Szárítógép
Modell: VTD56EASVWB

Szüksége van segítségre?

Ha segítségre van szüksége GE VTD56EASVWB, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Szárítógép GE

GE

GE GFD40ESCMWW Útmutató

17 December 2024
GE

GE SBSD137HMS Útmutató

8 December 2024
GE

GE FPDW1 Útmutató

8 December 2024
GE

GE Profile PFD95GSPTDS Útmutató

16 Október 2024
GE

GE SensorDry GHDN520EDWS Útmutató

6 Október 2024
GE

GE DMCD330GGWC Útmutató

4 Október 2024
GE

GE DLSR483EGWW Útmutató

4 Október 2024
GE

GE GLDP280GDWS Útmutató

2 Október 2024
GE

GE DSKS433ETAB Útmutató

1 Október 2024
GE

GE 7.0 cu. ft. capacity DuraDrum GTDP350EMWS Útmutató

29 Szeptember 2024

Útmutatók Szárítógép

Legújabb útmutatók Szárítógép

Zanussi

Zanussi ZTA 245 Útmutató

9 Április 2025
Bauknecht

Bauknecht TKL M11 72 Útmutató

9 Április 2025
Amana

Amana NGD4600YQ Útmutató

9 Április 2025
Whirlpool

Whirlpool awz 9479 Útmutató

9 Április 2025
AEG

AEG 65770IH3 Útmutató

7 Április 2025
Arçelik

Arçelik 901 KMP IG Útmutató

7 Április 2025
Arçelik

Arçelik 901 KMP I Útmutató

7 Április 2025
Miele

Miele METEOR 285C Útmutató

6 Április 2025
Miele Professional

Miele Professional PT 8203 SL WP Útmutató

6 Április 2025
Asko

Asko tc 741 Útmutató

6 Április 2025