Használati útmutató Fluke 78
Fluke
multiméter
78
Olvassa el alább 📖 a magyar nyelvű használati útmutatót Fluke 78 (64 oldal) a multiméter kategóriában. Ezt az útmutatót 11 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra
Oldal 1/64
®
78
Automotive Meter
Service Manual
For IEC 61010 CAT II Meters Only
PN 666617
November 1998
© 1998 Fluke Corporation, All rights reserved. Printed in U.S.A.
All product names are trademarks of their respective companies.
LIMITED WARRANTY & LIMITATION OF LIABILITY
Fluke Corporation (Fluke) warrants this product to be free from defects in material and workmanship under normal use and service for the life
of the product. This warranty extends only to the original buyer or end-user customer of a Fluke authorized reseller, and does not apply to
fuses, batteries or to any product which, in Fluke’s opinion, has been misused, altered, neglected or damaged by accident or abnormal
conditions of operation or handling. Fluke warrants that software will operate on appropriate Fluke instruments substantially in accordance
with its functional specifications for 90 days and that it has been properly recorded on non-defective media. Fluke does not warrant that
software will be error free or operate without interruption.
Fluke authorized resellers shall extend this warranty on new and unused products to end-user customers only but have no authority to
extend a greater or different warranty on behalf of Fluke.
Fluke’s warranty obligation is limited, at Fluke’s option, to refund of the purchase price, or free of charge repair or replacement of a defective
product which is returned to an authorized Fluke Service Center within the warranty period.
To obtain warranty service, contact your nearest Fluke Service Center or send the product, with a description of the difficulty, postage and
insurance prepaid (FCA Destination), to the nearest Fluke Service Center. Fluke assumes no risk for damage in transit. Following warranty
repair, the product will be returned to Buyer, transportation prepaid (FCA Destination). If Fluke determines that the failure was caused by
misuse, alteration, accident or abnormal condition of operation or handling, Fluke will provide an estimate of repair costs and obtain
authorization before commencing the work. Following repair, the product will be returned to the Buyer transportation prepaid and the Buyer
will be billed for the repair and return transportation charges (FCA Shipping Point).
Warranty service is available outside the United States only if product was purchased through a Fluke Authorized Sales Outlet in the country
of use or the applicable Fluke international price was paid. Product transported from the United States for which the applicable Fluke
international price was not paid must be returned to the U.S. to receive warranty service, at the shipment expense and risk of Buyer. Fluke
reserves the right to invoice Buyer for importation costs of repair/replacement parts when product purchased in one country is submitted for
repair in another country.
THIS WARRANTY IS PURCHASER’S SOLE AND EXCLUSIVE REMEDY AND IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE. FLUKE SHALL NOT BE LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES OR
LOSSES, INCLUDING LOSS OF DATA, WHETHER ARISING FROM BREACH OF WARRANTY OR BASED ON CONTRACT, TORT,
RELIANCE OR ANY OTHER THEORY.
Since some countries or states do not allow limitation of the term of an implied warranty, or exclusion or limitation of incidental or
consequential damages, the limitations and exclusions of this warranty may not apply to every buyer. If any provision of this Warranty is held
invalid or unenforceable by a court of competent jurisdiction, such holding will not affect the validity or enforceability of any other provision of
this warranty.
Fluke Corporation Fluke Europe B.V.
P.O. Box 9090 P.O. Box 1186
Everett WA 5602 B.D. Eindhoven
98206-9090 The Netherlands
Safety Information
This meter complies with EN 61010-1:1993, ANSI/ISA S82.01-1994 and CAN/CSA
C22.2 No. 1010.1-92 Overvoltage Category II. Use the meter only as specified in the
Users Manual, otherwise the protection provided by the meter may be impaired.
A Warning identifies conditions and actions that pose hazards to the user; a Caution
identifies conditions and actions that might damage the meter. International electrical
symbols used on the meter are shown below.
W Warning
To avoid possible electric shock or personal injury:
• Do not use the meter if it is damaged. Before use, inspect the
case for cracks or missing plastic. Pay particular attention to the
insulation surrounding the connectors.
• Always turn off power to the circuit before cutting, unsoldering,
or breaking the circuit. Small amounts of current can be
dangerous.
• Inspect the test leads for damaged insulation or exposed metal.
Check test lead continuity. Replace damaged leads.
• To avoid damage or injury, never use the meter on unprotected
circuits that exceed 4800 volt-amps.
• Do not use the meter if it operates abnormally. Protection may be
impaired. When in doubt, have the meter serviced.
• Do not operate the meter around explosive gas, vapor or dust.
• Do not apply more than 300 V dc or ac rms (sine) between
terminals or between any terminal and earth ground.
• Before each use, verify the meter’s operation by measuring a
known voltage.
• When servicing the meter, use only specified replacement parts.
• Use caution when working above 30 V ac rms, 42 V ac peak, or 60
V dc. Such voltages pose a shock hazard.
• Keep your fingers behind the finger guards on the probe when
making measurements.
• Connect the common test lead before connecting the live test
lead. Disconnect the live test lead first.
• Remove test leads from the meter before opening the case.
• Use only a single 9 V battery, properly installed in the meter case,
to power the meter.
• Follow all equipment safety procedures.
• Before measuring current, check the meter’s fuses (see “How to
Test the Fuse”).
• Never touch the probe to a voltage source when the test leads are
plugged into the 10 A input jack.
Termékspecifikációk
| Márka: | Fluke |
| Kategória: | multiméter |
| Modell: | 78 |
Szüksége van segítségre?
Ha segítségre van szüksége Fluke 78, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók multiméter Fluke
2 Október 2024
10 Szeptember 2024
10 Szeptember 2024
2 Szeptember 2024
30 Augusztus 2024
24 Augusztus 2024
21 Augusztus 2024
20 Augusztus 2024
20 Augusztus 2024
19 Augusztus 2024
Útmutatók multiméter
- multiméter PeakTech
- multiméter Milwaukee
- multiméter Parkside
- multiméter Maxwell
- multiméter Emos
- multiméter Voltcraft
- multiméter Vimar
- multiméter Digitus
- multiméter GW Instek
- multiméter Owon
- multiméter Aim TTi
- multiméter Gossen Metrawatt
- multiméter Amiko
- multiméter Klein Tools
- multiméter Chauvin Arnoux
- multiméter Workzone
- multiméter Beha-Amprobe
- multiméter Qian
- multiméter Joy-It
- multiméter Extech
- multiméter Gembird
- multiméter Testo
- multiméter Powerfix
- multiméter Biltema
- multiméter BaseTech
- multiméter REV
- multiméter BENNING
- multiméter Alecto
- multiméter Yato
- multiméter Velleman
- multiméter TFA
- multiméter Monacor
- multiméter Elro
- multiméter Uni-T
- multiméter Metrix
- multiméter Abus
- multiméter Megger
- multiméter Testboy
- multiméter Sonel
- multiméter Wiha
- multiméter Schneider
- multiméter Kyoritsu
- multiméter Brandson
- multiméter Stanley
- multiméter Silverline
- multiméter Rigol
- multiméter Projecta
- multiméter Multimetrix
- multiméter Weidmüller
- multiméter Laserliner
- multiméter Appa
- multiméter Amprobe
- multiméter Brennenstuhl
- multiméter Ferm
- multiméter Tacklife
- multiméter Somogyi
- multiméter Profile
- multiméter Steren
- multiméter Perel
- multiméter Flir
- multiméter Proline
- multiméter Hager
- multiméter Topcraft
- multiméter Clas Ohlson
- multiméter Plieger
- multiméter Jung
- multiméter Etekcity
- multiméter Cablexpert
- multiméter Greenlee
- multiméter Högert
- multiméter Wago
- multiméter Bruder Mannesmann
- multiméter Keithley
- multiméter Metrel
- multiméter Digi-tool
- multiméter Skandia
- multiméter Elma
- multiméter Hubinont
- multiméter Kewtech
- multiméter Strex
- multiméter Mastech
- multiméter MBS
- multiméter MGL Avionics
- multiméter PCE Instruments
- multiméter Micronta
- multiméter CEM
- multiméter Horex
- multiméter Cosinus
- multiméter Kurth Electronic
- multiméter Testec
- multiméter IWH
- multiméter Weltron
- multiméter Sanwa
- multiméter Rohde & Schwarz
- multiméter EEVBlog
- multiméter Kingcraft
- multiméter HT Instruments
- multiméter Caltek
- multiméter Elworks
- multiméter Bearware
- multiméter Noyafa
Legújabb útmutatók multiméter
3 Április 2025
3 Április 2025
3 Április 2025
3 Április 2025
3 Április 2025
3 Április 2025
3 Április 2025
28 Március 2025
26 Március 2025
14 Január 2025