Használati útmutató DeLonghi DCH 6031.B

DeLonghi Fűtő DCH 6031.B

Olvassa el alább 📖 a magyar nyelvű használati útmutatót DeLonghi DCH 6031.B (3 oldal) a Fűtő kategóriában. Ezt az útmutatót 5 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/3
7
DESCRIPTION
(see g. 1)
A ON/STAND-BY button
B +/- adjustment buttons
C MODE button (selects the operating mode)
D “ECO plus” button
E Timer button
F Swing button
G Remote control receiver
H Remote control
I Indicator light
J Air intake grille
K Filter
USE
Installation
The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same
socket for other appliances.
Electrical connection
- Before plugging the appliance into the mains socket,
check that the mains power supply corresponds to the
value indicated on the rating plate and that the mains
power supply is adequate for the load.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/
EEC ON RADIO INTERFERENCE SUPPRESSION.
Operation and use
- Plug into the mains socket.
- The appliance emits a beep. The indicator light ( ) comes I
on and remains lit while the appliance is powered.
- The appliance switches to stand-by. A dot ashing
on the display means the tip over device has been
activated. See paragraph: “Safety functions”.
- Press the ON/STAND-BY ( ) to turn the appliance on. A
It begins heating the room according to the current
settings.
- Press the MODE button (C) to select one of the following
operating modes:
- Fan
In this mode, only the fan operates and the appliance
does not heat the room.
- Freeze prevention
In this mode, the appliance keeps the room at a
temperature of 7°C to avoid freezing.
- Heating
In this mode, the desired temperature can be selected
by pressing the adjustment buttons + and – ( ): B
- Heating
Silent+
The appliance operates at minimum power, automati-
cally reducing energy consumption and noise level. The
tones emitted by the commands are lower than in other
modes for even more silent operation.
- Heating
The appliance operates at medium power.
- Heating
The appliance operates at high power to heat the room
rapidly.
- To turn the appliance o, press the ON/STAND-BY
button ( ). The display may visualize a countdown for A
about 6 seconds.
Please note: Room temperature can be displayed in
either °C or °F. To change the unit of measurement for the
temperature, press the + button for a few seconds, then
release.
“ECO plus” function
The “ECO plus” function is available in Heating 1, 2 and 3 modes
only. To activate the function, press the ECO plus” button (“ D).
When this function is active the appliance automatically sets
the most appropriate power level to guarantee optimum
comfort while reducing energy consumption.
While the ECO plus” function is active, the appliance may “
switch automatically to a lower heating power than the one
displayed. This may happen a number of times in an hour.
Swing button
To distribute the air ow over a wider surface, press the swing
button ( . The appliance starts swinging to the right F)
and left. To stop the appliance in the desired position, simply
press the swing button ( ) again.F
Digital 24 h timer
This function can be activated from any operating mode.
Auto-start: with the appliance in STAND-BY, press the timer
button (E). The symbol is displayed together with
the time remaining before the appliance comes on.
To adjust the timer, use the adjustment buttons + and - (B),
then wait a few seconds for the setting to be memorised. The
stand-by light ( ) is displayed together with the symbol, I
indicating that the timer has been set.
When the programmed time is reached, the appliance comes
on with the settings used during the previous period of
operation.
8
Auto-o: with the appliance on, press the timer button
( symbol is displayed together with the time E). The
remaining before the appliance goes o.
To set the timer, use the adjustment buttons + and - (B),
then wait a few seconds for the setting to be memorised.
The current settings are displayed again, together with the
symbol indicating that the timer has been set.
When the programmed time is reached, the appliance goes
o automatically. To go back to operation without the timer,
press the timer button ( ) twice. E
The timer symbol disappears from the display.
USING THE REMOTE CONTROL
The functions on the remote control are the same as those on
the appliance control panel.
For a description of the functions, see the “Operation and use”
section on the previous page.
Inserting or replacing the batteries
- The remote control is
provided with a lithium
battery CR2032. To let
the appliance function,
remove the battery cover
strip, by pulling it.
- To replace the batteries,
remove the battery cover
by rotating it. Replace the
battery paying attention to
respect the right polarity as shown in gure 1.
- Replace the cover rotating it towards the position .
- Old batteries must be removed and disposed o in
accordance with current legislation as they are harmful
to the environment.
MAINTENANCE
- Always unplug from the mains socket before cleaning.
- During the season when the appliance is in use, clean
the air intake and outlet grilles regularly using a vacuum
cleaner.
- To clean the lter, remove the rear grille by pulling it
outwards.
Remove the dust lter which retains impurities in the air
drawn in from the room, blow on it lightly then replace
in the appliance.
- Never use abrasive powders or solvents to clean the
appliance.
TECHNICAL CHARACTERISTICS
Supply voltage See rating plate
Absorbed power “
Fig. 2
9
PROBLEM CAUSE SOLUTION
PF display and emits a beep Temperature sensor is not working
properly
Please contact Customer Service
Product doesn’t turn on Check that the plug is connected to the
outlet
Auto-start is on
Room temperature reaches the set
temperature
Plug in
Wait till time elapsed or press the but-
ton (E) twice to cancel the auto-start
and push the button (A)
Use the “+” button to increase the set
temperature
The appliance goes o unexpectedly Check that the plug is connected to the
outlet
The set temperature has been reached
or the time set on the timer has elapsed
Plug in
A dot is ashing and unit is o The tip-over switch has been activated Make sure the appliance is standing
upright on a at surface.
If the appli-
ance doesn’t work please contact Cus-
tomer Service
The display shows " " blinkingHtThe internal temperature is too high.
The air intake or outlet grille is
obstructed
Check the appliance is correctly
positioned respecting the minum
distances from the wall, or objects, as
indicated on the instruction manual,
if not, position the appliance correctly
Remove the obstruction
Disconnect the plug from the outlet
and let the appliance cool down. After
few minutes plug the appliance again.
If the appliance doesn't work
please
contact Customer Service
TROUBLESHOOTING

Termékspecifikációk

Márka: DeLonghi
Kategória: Fűtő
Modell: DCH 6031.B

Szüksége van segítségre?

Ha segítségre van szüksége DeLonghi DCH 6031.B, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Fűtő DeLonghi

DeLonghi

DeLonghi RHJ21F1015 Útmutató

27 Március 2025
DeLonghi

DeLonghi HFX30C18LG Útmutató

3 Január 2025
DeLonghi

DeLonghi Caldobagno HBC 3030 Útmutató

5 December 2024
DeLonghi

DeLonghi EW7707CBCA Útmutató

3 Október 2024
DeLonghi

DeLonghi HOR KH770720V Útmutató

23 Szeptember 2024
DeLonghi

DeLonghi Slim Style HCX3120FS Útmutató

15 Szeptember 2024
DeLonghi

DeLonghi Radia S TRRS0715E Útmutató

10 Szeptember 2024
DeLonghi

DeLonghi HMP 1500 Útmutató

5 Szeptember 2024
DeLonghi

DeLonghi MARCO1000AN Útmutató

2 Szeptember 2024
DeLonghi

DeLonghi TRRS0715EG Útmutató

2 Szeptember 2024

Útmutatók Fűtő

Legújabb útmutatók Fűtő

Dimplex

Dimplex VFMi 60C Útmutató

6 Április 2025
Scandia

Scandia Styliste’ 6 Útmutató

4 Április 2025
Einhell

Einhell MR 7 S Útmutató

30 Március 2025
Argoclima

Argoclima Dori Night Útmutató

30 Március 2025
Dimplex

Dimplex 2NC81524L Útmutató

30 Március 2025
Dimplex

Dimplex FXL24i Útmutató

30 Március 2025
Rinnai

Rinnai GEPH-22DTW Útmutató

27 Március 2025
Einhell

Einhell NKH 1500 Útmutató

27 Március 2025
Einhell

Einhell NBH 2000 H Útmutató

27 Március 2025
Einhell

Einhell NWW 1800 Útmutató

27 Március 2025