Használati útmutató Definitive Technology BP-8040ST

Definitive Technology hangszóró BP-8040ST

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Definitive Technology BP-8040ST (12 oldal) a hangszóró kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/12
Definitive Technology
BIPOLAR SUPERTOWER
OWNER’S MANUAL
BP-8000 SuperTower®Series:
BP-8080ST, BP-8060ST, BP-8040ST, BP-8020ST
Thank you for choosing the Definitive Technology Bipolar SuperTower Loudspeaker
System. The Bipolar ST is a unique speaker which features For d-Focused Bipolarwar
array technology and a built-in powered subwoofer. This extraordinary speaker is truly
state-of-the-art in music and home theater loudspeaker technology and performance.
You have chosen wisely.
Our engineers have spent many years in developing this product. In order to ensure
that you experience the finest performance possible, we encourage you to take a
moment to fully read this owner’s manual and familiarize yourself with the proper
installation and set-up procedures for your Bipolar ST speakers.
www.DefinitiveTech.com
CAUTION: Important Safety Instructions
WARNING: DO NOT OPERATE SPEAKER WITHOUT
STABILIZER FEET INSTALLED
Accessories included in your Bipolar ST box:
1. Stabilizer Feet: Qty (4) BP-8080ST, BP-8060ST, and BP-8040ST; Qty (2) BP-8020ST
2. Philips Head Screws: Qty (8) BP-8080ST, BP-8060ST, and BP-8040ST;
Qty (4) BP-8020ST
3. Carpet Spikes: Qty (4) all models
4. Hard Floor Glides: Qty (4) all models
Accessory Installation
Power Supply
1. The fuse and power disconnect device are located on the back of the speaker.
2. The disconnect device is the power cord, detachable at either the speaker
or the wall.
Unpacking Your BP-8000 Super Tower
Please Inspect For Shipping Damage
Each loudspeaker leaves our plant in perfect condition. Any visible or concealed
damage most likely occurred in handling after it left our plant and should be
reported to your Definitive dealer or the delivery company that delivered your
loudspeaker. Please unpack your system carefully. Save all cartons and packing
materials in case you move or need to ship your system. Record the serial number
found on the back of the Bipolar 8000ST speaker.
Positioning the Speakers in Your Room
Your new Bipolar speakers are very flexible in terms of positioning and placement.
To optimize their performance, please follow these simple guidelines. Although the
following recommendations will usually yield the best results, all rooms and listen-
ing setsups are different,
so do not be afraid to
experiment with the
speaker placement.
Whatever sounds best to
you is correct.
Figure 2 –
Positioning Bipolar
ST as Left/Right
Main Speakers
Set up the speakers and
listening position in an
equilateral triangle as
illustrated. You will also
get good results if the
listeners are a bit farther away. For example, if line A and C are each 10' long then
line B would be between 7' and 8' long.
Definitive Technology
Safety Precautions
Safety Precautions
CAUTION! To reduce the risk of electric shock and fire, do not remove the
cover or back plate of this device. There are no user serviceable parts inside.
Please refer all servicing to licensed service technicians. Avis: Risque de choc
electricque, ne pas ouvrir.
CAUTION! The international symbol of a lightning bolt inside a triangle is
intended to alert the user to uninsulated “dangerous voltage” within the
device’s enclosure. The international symbol of an exclamation point inside
a triangle is intended to alert the user to the presence of important operat-
ing, maintenance and servicing information in the manual accompanying
the device.
CAUTION! To prevent electrical shock, match wide blade of plug to wide
slot, fully insert. Attention: Pour eviter les chocs electriques, introduire la
lame la plus large de la fiche dans la borne correspondante de la prise et
pousser jusqu'au fond.
CAUTION! To reduce the risk of electrical shock, do not expose this equip-
ment to rain or moisture.
1. Read Instructions—All safety and operating instructions should be read
before operating the device.
2. Retain Instructions—The safety and operating instructions should be
retained for future reference.
3. Heed Warnings—All warnings on the device and in the operating
instructions should be adhered to.
4. Follow Instructions—All operating and safety instructions should be
followed.
5. Water & Moisture—The device should never be used in, on or near
water for risk of fatal shock.
6. Carts & Stands—The device should only be used on carts or stands rec-
ommended by the manufacturer.
7. Wall & Ceiling Mounting—The device should be mounted on a wall or
ceiling only as recommended by the manufacturer.
8. Ventilation—The device should always be located in such a way that it
maintains proper ventilation.
It should never be placed in a built-in installation or anywhere that
may impede the flow of air through its heat sink.
9. Heat—Never locate the device near heat sources such as radiators, floor
registers, stoves or other heat-generating devices.
10. Power Supply—The device should only be connected to a power supply
of the type described in the operating instructions or as marked on the
device.
11. Power Cord Protection—Power cables should be routed so they are not
likely to be stepped on or crushed by items placed on them or against
them. Special attention should be paid to areas where the plug enters a
socket or fused strip and where the cord exits the device.
12. Cleaning—The device should be cleaned in accordance with manufac-
turer’s instructions.
13. Periods Of Non-Use—The device should be unplugged when not being
used for extended periods.
14. Dangerous Entry—Care should be taken that no foreign objects or
liquids fall or are spilled inside the device.
15. Damage Requiring Service—The device should be serviced by licensed
technicians when:
• The plug or power supply cord has been damaged.
• Objects have fallen on or liquid has spilled inside the device.
• The device has been exposed to moisture.
• The device does not appear to be operating properly or exhibits a
marked change in performance.
• The device has been dropped or the cabinet becomes damaged.
16. Service—The device should always be serviced by licensed technicians.
Only replacement parts specified by the manufacturer should be used.
The use of unauthorized substitutions may result in fire, shock, or other
hazards.
2
BIPOLAR SUPERTOWER
OWNER’S MANUAL
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Figure 1 – Stabilizer Feet
*Definitive Technology is
not responsible for damage
to floors caused by misuse
of the provided accessories.
Stabilizer Feet and Screws
Optional Carpet Spikes
4”
(10 cm)
6”
(30 cm)
6”
(30 cm)
>
>
A
B
C
3
Connecting Your Loudspeakers
Figure 3 – Wiring and Polarity
Wiring Options: High Level, High Level and LFE w/ “Y” Connector
VERY IMPORTANT:
Do not use your receiver’s auto setup functions as they are often
ineffective in setting up and adjusting speakers with built-in
powered subwoofers!
Use the manual speaker setup func-
tions in your receiver to set speaker
configuration, speaker distance and
channel balance. Consult your
receiver’s or processor’s manual to
learn how to access and use the setup
menus. Use the settings called for in
Figur 4.e
Powering the Active Subwoofer
Your Bipolar STs contain a built-in subwoofer amplifier that must be plugged into
an electrical socket. When powering up from being unplugged, the LED on the
amplifier panel will flash for 30 seconds while the firmware is loading. The
Bipolar ST has a special circuit which automatically turns on when a signal is fed
to the loudspeaker. The LED on the back panel will light up when a signal is
sensed and the amplifier turns on. After the cessation of a signal, it may take up
to an hour for the amplifier to turn off. Due to stray radio signals (RF) in your
area, the LEDs may not turn off. Do not be concerned, the amplifiers draw little
power when they are idle.
Setting Your Speakers’ Low-Frequency Level Control
Your Bipolar STs have bass level controls which allow you to adjust the output
level of the powered subwoofers to match your room and personal listening
preferences. Please note that there are no controls to
vary the crossover points or phase. The crossover
points and phase have been factory-calibrated to
provide perfect blending. We suggest beginning with
the level control set at approximately 12 o’clock.
Each speaker’s bass controls can also be set differently
in order to allow you to compensate for asymmetrical
positioning of the speakers in your room (i.e., when
one is closer to a side wall or corner, etc.).
Complete Home Theater System
We strongly suggest that you use matching Definitive center channel and
rear/surround speakers to complete your Definitive home theater system. Please
note that you can use Definitive Bipolar SuperTowers as rear or side surround
speakers with excellent results for both music and movies.
Troubleshooting
If you experience any difficulties with your Bipolar ST loudspeakers, try the
suggestions below. If you still have problems, contact your Definitive Technology
Authorized Dealer for assistance.
1. Audible distortion when the speakers are playing at loud levels is caused
by turning up your receiver or amplifier louder than the receiver or the
speakers are capable of playing. Most receivers and amplifiers put out their
full-rated power well befor the volume control is turned all the way up, so e
the position of the volume control is a poor indicator of its power limit. If
your speakers distort when you play them loud, turn the volume down!
2. If you experience a lack of bass, it is likely that one speaker is out of phase
(polarity) with the other and needs to be rewired with closer attention to
connecting positive to positive and negative to negative on both channels.
Most speaker wire has some indicator (such as color-coding, ribbing or
writing) on one of the two conductors to help you maintain consistency.
It is essential to connect both speakers to the amplifier in the same way
(in phase).
3. Make sure all your system interconnects and power cords are solidly in place.
4. Should you hear hum or noise coming from your speakers, try plugging
the speakers’ power cords into a different AC circuit than your amplifier.
5. The system has sophisticated internal protection circuitry. If for some
reason the protection circuitry trips, turn off your system and wait five
minutes before trying the system again. If the speakers’ built-in amplifier
should over-heat, the system will turn off until the amplifier cools down
and resets.
6. Check to be sure that your power cord has not been damaged.
7. Check that no foreign objects or liquid has entered the speaker cabinet.
8. If you cannot get the subwoofer driver to turn on or if no sound comes out
and you are sure the system is set up properly, please bring the loudspeaker
to your Definitive Technology Authorized Dealer for assistance; call first.
RECE IV ER/
AMPL IF IE R
Receiver/Amplifier
+
-
Strip 1/4" (6mm) wire. Identify markings on wire and assign +/-.
Ensure that the speaker is always con-
nected to the receiver or amplifier + to +
and – to –.
Speaker Setup
Speaker Sub
Large Yes
Subwoofer
level
Subwoofer
level
LFE
speaker output
LFE
Receiver/Amplifier
Right Left
“Y” Connector *available from dealer
Subwoofer
level
on/of LEDf
LFE
Connection Option 1
Receiver/Amplifier
speaker output
Speaker Setup
Speaker Sub
Large No
Figure 4 – Receiver Settings
LFE
Connection Option 2
Min Max
1. Unscrew binding post and insert wire.
2. Tighten until wire is secure.
1
2
BIPOLAR SUPERTOWER
OWNER’S MANUAL

Termékspecifikációk

Márka: Definitive Technology
Kategória: hangszóró
Modell: BP-8040ST

Szüksége van segítségre?

Ha segítségre van szüksége Definitive Technology BP-8040ST, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók hangszóró Definitive Technology

Definitive Technology

Definitive Technology Dymension LS-400 Útmutató

8 Január 2025
Definitive Technology

Definitive Technology Dymension Outdoor LS- Útmutató

8 Január 2025
Definitive Technology

Definitive Technology Dymension LS-80 Útmutató

8 Január 2025
Definitive Technology

Definitive Technology Dymension Outdoor AW-550 Útmutató

2 Január 2025
Definitive Technology

Definitive Technology UIW 64/A Útmutató

30 December 2025
Definitive Technology

Definitive Technology Dymension Outdoor BL-550 Útmutató

7 December 2024
Definitive Technology

Definitive Technology Dymension Outdoor BL-650 Útmutató

7 December 2024
Definitive Technology

Definitive Technology XTR-40BP Útmutató

8 Szeptember 2024
Definitive Technology

Definitive Technology Dymension DW-45 MAX Útmutató

4 Szeptember 2024
Definitive Technology

Definitive Technology Dymension DW-65 MAX Útmutató

4 Szeptember 2024

Útmutatók hangszóró

Legújabb útmutatók hangszóró

Match

Match UP C42BMW-FRT.3 Útmutató

3 Április 2025
Turbosound

Turbosound PQ12-SB Útmutató

3 Április 2025
Trust

Trust Tytan GXT 658 Útmutató

3 Április 2025
Turbosound

Turbosound PQ15-YB Útmutató

3 Április 2025
Klipsch

Klipsch Synergy KSB-S1 Útmutató

3 Április 2025
Klipsch

Klipsch Synergy KSF-10.5 Útmutató

3 Április 2025
Klipsch

Klipsch kO-R1 Útmutató

3 Április 2025
Klipsch

Klipsch Synergy SB-1 Útmutató

3 Április 2025
Klipsch

Klipsch Reference RB-5 II Útmutató

3 Április 2025
Klipsch

Klipsch Contractor CS-800-R Útmutató

3 Április 2025