Használati útmutató Da-Lite Tensioned Professional Electrol

Da-Lite Vetítővászon Tensioned Professional Electrol

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Da-Lite Tensioned Professional Electrol (12 oldal) a Vetítővászon kategóriában. Ezt az útmutatót 5 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/12
INSTRUCTION BOOK FOR
Tensioned Professional Electrol®
2
Important Safety Instructions
When using your video equipment, basic safety precautions
should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating
at least equal to that of the appliance should be used. Cords
rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended by
the manufacturer may cause a risk ofire, electric shock, or
injury to persons.
6. Failure to provide adequate structural strength for this
component can result in serious personal injury or damage
to equipment! It is the installer’s responsibility to make sure
the structure to which this component is attached can
support the weight of all equipment. Reinforce the structure
as required before installing the component.
7. Use this projection screen only for its intended use as
described in these instructions. Do not use attachments not
recommended by the manufacturer.
Save These Instructions
Pre-Installation
1. Carefully unpack screen.
2. Make sure to recheck measurements of screen location
before installation.
3. Remove instruction cover plate (Fig. 1). Do not remove
wrapping paper until screen is installed.
4. Remove the retainer screws from the slat bar before the
case has been installed (Fig. 2).
Figure 2
Slat Retainer Bracket
(3 Screws)
1 On Bottom of Slat
2 On Inside of Case
Figure 1
Instruction Cover
Case
Original Instructions
Disclaimer
Milestone and its ailiated corporations and subsidiaries
(collectively "Milestone"), intend to make this manual accurate
and complete. However, Milestone makes no claim that the
information contained herein covers all details, conditions or
variations, nor does it provide for every possible contingency in
connection with the installation or use of this subject to change
without notice or obligation of any kind. Milestone makes no
representation of warranty, expressed or implied, regarding the
information contained herein. Milestone assumes no
responsibility for accuracy, completeness or suiciency of the
information contained in this document.
Da-Lite® is a registered trademark of Milestone AV Technologies.
All rights reserved.
3
Hangers (If required)
1. See Figure 3 for hanger placement.
2. Make sure hangers are placed to it into notches of
ironing board..
Installation
11
1
2
"
11
1
2
"
Screens Over 22' Wide
Figure 3
11
1
2
"
11
1
2
"
Screens 22' Wide And Under
Case Length ÷ 2
Case Length ÷ 2
(Case Length – 23") ÷ 3
(Case Length – 23") ÷ 3
(Case Length – 23") ÷ 3

Termékspecifikációk

Márka: Da-Lite
Kategória: Vetítővászon
Modell: Tensioned Professional Electrol

Szüksége van segítségre?

Ha segítségre van szüksége Da-Lite Tensioned Professional Electrol, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók Vetítővászon Da-Lite

Útmutatók Vetítővászon

Legújabb útmutatók Vetítővászon

EPV

EPV EF125C-A4K Útmutató

3 Április 2025
Optoma

Optoma DS-3120PMG Útmutató

11 Október 2024
Optoma

Optoma DS-9120PMG Útmutató

29 Szeptember 2024
Draper

Draper Clarion Útmutató

22 Szeptember 2024
Draper

Draper Luma 207008 Útmutató

6 Szeptember 2024
Draper

Draper DR230109 Útmutató

4 Szeptember 2024
EPV

EPV PGF106WH1-A4K Útmutató

3 Szeptember 2024
EPV

EPV PGF84WH1 Útmutató

3 Szeptember 2024