Használati útmutató Boss OC-5

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Boss OC-5 (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/2
* 5100072383- 01*
Owners Manual
Before using this unit, carefully read “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (supplied on a separate
sheet).
After reading, keep the document(s) where it will be available for immediate reference.
AC adaptor
(PSA series; sold
separately)
Guitar
Bass
English
Guitar Amp
DC IN jack
In addition to 9-volt battery operation, this unit can also operate on an AC adaptor
(BOSS PSA series; sold separately).
* Use only the specied AC adaptor (PSA series; sold
separately), and connect it to an AC outlet of the correct
voltage.
* If the AC adaptor is connected while a battery is installed,
the power supply is drawn from the AC adaptor.
CHECK indicator
The indicator lights when an eect is ON.
* The brightness of the CHECK indicator (LED) will dim as the battery
lowers. Replace the battery when the LED is dim or does not light. For
instructions, refer to Changing the Battery.
* The CHECK indicator shows whether the eect is on or o.
-1OCT LEVEL knob
This knob adjusts the volume of the sound that is one octave below the
direct sound.
+1OCT LEVEL knob
This knob adjusts the volume of the sound that is one octave above the
direct sound.
Pedal switch
This switch turns the
eects ON/OFF.
Thumbscrew
When this screw is loosened, the pedal will open, allowing you to change the battery.
* For instructions on changing the battery, refer to “Changing the Battery.
Panel Descriptions
Precautions When Connecting
• To prevent malfunction and equipment failure, always turn
down the volume, and turn o all the units before making any
connections.
• Once everything is properly connected, be sure to follow the
procedure below to turn on their power. If you turn on equipment
in the wrong order, you risk causing malfunction or equipment
failure.
When powering
up:
Turn on the power to your
guitar amp last.
When powering
down:
Turn o the power to your
guitar amp rst.
• Before turning the unit on/o, always be sure to turn the volume
down. Even with the volume turned down, you might hear some
sound when switching the unit on/o. However, this is normal and
does not indicate a malfunction.
Use of Battery
• If operating this unit on battery, please use alkaline battery.
• The life of the included battery may be limited as its primary
purpose was for testing during assembly.
• When operating on battery power only, the units indicator will
become dim when battery power gets too low. Replace the
battery as soon as possible.
• If you handle batteries improperly, you risk explosion and uid
leakage. Make sure that you carefully observe all of the items
related to batteries that are listed in “USING THE UNIT SAFELY” and
“IMPORTANT NOTES” (supplied on a separate sheet).
Additional Precautions
• When disposing of the packing carton or cushioning material in
which this unit was packed, you must observe the waste disposal
regulations that apply to your locality.
• Do not use connection cables that contain a built-in resistor.
Changing the Battery
1. Hold down the pedal and loosen the
thumbscrew, then open the pedal upward.
Thumbscrew
Battery housing
Pedal
Spring base
Coil spring
Guide
bush hole
Battery
snap cord
Battery
snap
Battery
* The pedal can be opened without detaching the
thumbscrew completely.
2. Remove the old battery from the battery
housing, and remove the snap cord
connected to it.
3. Connect the battery snap to the new battery,
and place the battery inside the battery
housing.
* Be sure to carefully observe the battery’s polarity
(+ versus -).
4. Slip the coil spring onto the spring base on
the back of the pedal, and then close the
pedal.
* Carefully avoid getting the snap cord caught in the
pedal, coil spring, and battery housing.
5. Finally, hold down the pedal while tightening
the thumbscrew into the guide bush hole.
Main Specications
Nominal Input Level -20 dBu
Input Impedance 1 MΩ
Nominal Output Level -20 dBu
Output Impedance 1 kΩ
Recommended Load
Impedance 10 kΩ or greater
Power Supply Alkaline battery (9 V, 6LR61 or 6LF22)
AC adaptor (PSA series: sold separately)
Current Draw
55 mA
* Expected battery life under continuous
use:
Alkaline battery: Approx. 7 hours
These gures will vary depending on
the actual conditions of use.
Dimensions 73 (W) x 129 (D) x 59 (H) mm
2-7/8 (W) x 5-1/8 (D) x 2-3/8 (H) inches
Weight
(including battery)
440 g
1 lb
Accessories
Owners Manual, Leaet (“USING THE
UNIT SAFELY,“IMPORTANT NOTES,“ and
“Information“), Alkaline battery (9 V, 6LR61
or 6LF22)
Option
(sold separately) AC adaptor (PSA-series)
• 0 dBu = 0.775 Vrms
• This document explains the specications of the product at the
time that the document was issued. For the latest information,
refer to the Roland website.
• Roland and BOSS are either registered trademarks or trademarks
of Roland Corporation in the United States and/or other countries.
© 2020 Roland Corporation
* The INPUT jack also serves as the power switch. Power is
turned on whenever a plug is inserted into the INPUT jack,
and is turned o when the plug is disconnected. When not
using the unit, you should disconnect any cord connected to
the INPUT jack.
* If you’re using this unit together with other eect units,
connect this unit rst in the chain (directly after the guitar).
If guitar sound processed by an eect is input to this unit, it
might not work correctly.
INPUT jack
This jack accepts input signals coming from a guitar (or bass).
DIRECT LEVEL knob
This knob adjusts the volume of the direct sound.
GUITAR/BASS switch
This switch selects settings that are suitable for a
guitar or a bass.
-2OCT/RANGE knob
The operation depends on the setting of the VINTAGE/POLY
switch.
Switch Explanation
VINTAGE
Operates as the -2OCT LEVEL knob. This knob
adjusts the volume of the sound that is two
octaves below the direct sound.
POLY
Operates as the RANGE knob. Adjusts the
bandwidth of the -1OCT eect.
As you turn this knob toward the right, the
eect applies to a wider range of frequencies
from low to high. As you turn this knob
toward the left, the eect is limited to the
low-frequency range. If this knob is turned all
the way to the left, the eect applies only to
the lowest note of the chord.
OUTPUT jack, DIRECT OUT jack
Use this jack to connect to the input
of your guitar amplier or the input of
additional eect unit.
* Output may vary according to the connections.
VINTAGE/POLY switch
This switch selects the character of the sound.
VINTAGE
Vintage sound that simulates the OC-2.
Play (input) single notes.
POLY
Polyphonic mode that supports chordal
input.
Connection
method Sound that is output
Connect only to
the OUTPUT jack
The direct sound and octave sound
are mixed and output.
Connect to the
OUTPUT jack
and the DIRECT
OUT jack
The octave sound is output from the
OUTPUT jack, and the direct sound is
output from the DIRECT OUT jack.
When the eect is o, the sound is
output only from the DIRECT OUT
jack.
For the USA
SUPPLIER’S DECLARATION OF CONFORMITY
Compliance Information Statement
Model Name :
Type of Equipment :
Responsible Party :
Address :
Telephone :
OC-5
Guitar Eects
Roland Corporation U.S.
5100 S. Eastern Avenue Los Angeles, CA 90040-2938
(323) 890-3700

Termékspecifikációk

Márka: Boss
Kategória: nincs kategorizálva
Modell: OC-5

Szüksége van segítségre?

Ha segítségre van szüksége Boss OC-5, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók nincs kategorizálva Boss

Boss

Boss PW-3 Útmutató

2 Szeptember 2024
Boss

Boss BCAM60 Útmutató

1 Szeptember 2024
Boss

Boss TU-80 Útmutató

29 Augusztus 2024
Boss

Boss Reverb RV-6 Útmutató

29 Augusztus 2024
Boss

Boss Reverb RV-200 Útmutató

26 Augusztus 2024
Boss

Boss SDE-3000D Útmutató

23 Augusztus 2024
Boss

Boss GT-1000CORE Útmutató

23 Augusztus 2024
Boss

Boss Pocket GT Útmutató

23 Augusztus 2024

Útmutatók nincs kategorizálva

Legújabb útmutatók nincs kategorizálva