Használati útmutató Audix D2

Audix mikrofon D2

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Audix D2 (2 oldal) a mikrofon kategóriában. Ezt az útmutatót 11 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/2
D2
OVERVIEW:
Designed, machined, assembled and tested by Audix in the
USA, the D2 is a dynamic instrument microphone used for stage,
studio and broadcast applications. The D2 is characterized with
a hypercardioid pickup pattern for isolation and feedback control
and is equipped with a VLM™ (Very Low Mass) diaphragm for
natural, accurate sound reproduction.
The D2 is lightweight, compact and easy to position. With a wide
frequency response of 80 Hz - 18 kHz and the ability to handle
sound pressure levels in excess of 144 dB, the D2 is an excellent
choice for miking instruments with a percussive nature such as
rack toms, congas, saxophone, guitar cabinets and brass.
Roadworthy construction includes a precision machined
aluminum body, black anodized nish, laser etched model and
serial number, steel mesh grill, Switchcraft® XLR connector and
includes a tension-t heavy duty nylon mic clip.
Transformerless design, low impedance and balanced output
allow for interference-free performance even with long cable runs.
APPLICATIONS:
Rack toms, congas, floor tom
Guitar and bass cabinets
Saxophone, brass
SUPPLIED ACCESSORIES:
Tension-fit heavy duty mic clip (DCLIP)
Carrying pouch (P1)
OPTIONAL ACCESSORIES:
TRIPOD - Mic stand
DFLEX - All purpose percussion clamp
DVICE - Spring loaded rim mount clamp
DCLAMP - Tension rod mic clamp
CBL-DR25 - 25’ right angle XLR cable
STAND-KD - Adjustable short boom mic stand
CAB GRABBER - Tension held mic holder, clamps to guitar cabinets
DYNAMIC INSTRUMENT MICROPHONE
D2
Dynamic Instrument
DCLAMP DFLEX DVICE & CBL-DR25 w/ D2 CAB GRABBER STAND-KD
FEATURES:
Compact, lightweight
Machined aluminum body
VLM (very low mass) diaphragm
Studio quality sound
Excellent mid-bass transient response
Handles extremely high SPL without distortion
Roadworthy construction
5 year warranty
SPECIFICATIONS: ARCHITECTS AND ENGINEERS SPECIFICATIONS:
The microphone shall be of the dynamic type operating on the moving coil principle and the
capsule shall be VLM Type B. The polar pattern of the microphone shall be hypercardioid. The
nominal output impedance shall be 250 ohms at 1 kHz.The microphone shall have a sensitivity of
1.2 mV / Pa at 1 kHz and will handle a sound pressure level of 144 dB. The microphone body ≥
shall be machined of aluminum and the grill cap shall be steel wire mesh. The overall dimensions
shall be 21.5 mm in diameter at the base, 39 mm in diameter at the widest point and 100 mm in
length. The microphone shall be the Audix D2.
www.audixusa.com Call: 503-682-6933 Fax: 503-682-7114
Audix Corporation 9400 SW Barber Street, Wilsonville, OR 97070
SERVICE AND WARRANTY:
This microphone is under warranty
for a period of 5 years from any and
all manufacturing defects. Should
your microphone fail in any way,
please contact the Audix Service
department at 503-682-6933. A Return
Authorization number is required
before returning any products.
CARE AND MAINTENANCE:
The D2 is manufactured to exacting specs with
roadworthy construction. However, the capsule
is highly sensitive and should be handled with
care. Avoid extreme temperatures and be sure
to store your microphone in the pouch provided
when not in use. Moisture of any kind can
adversely aect the sound and performance of
your microphone.
OPERATION:
The D2 is a low impedance microphone and should be plugged into a “mic level” of your console,
mixer, or recording device. Please note that your microphone does not require phantom power
and will not be eected in any way by phantom power should it be running simultaneously while
the microphone is in operation. Avoid plugging or unplugging the microphone from the PA system
unless the channel is muted or the volume of the system turned down. Failure to do so may result
in a loud “popping” noise which could seriously damage the speakers in the PA system.
USER TIPS:
The D2 has an extremely tight (hypercardioid) pick-up pattern in order to help eliminate sound
from other instruments on stage from “bleeding” into the microphone. For this reason, it the D2
is exceptionally eective in capturing the sound of each component of a drum or percussion kit.
Drums, hand percussion: As a general rule, the bottom of the D2 grill should be 1-2 inches
above the head of the drum and pointed towards the center. For more “ring” pull the mic back
towards the rim. For less ring and more overtones, position the mic 1-2 inches inside the ring. For
more attack, place the mic very close to the head and for more overtones and decay move the
mic further away from the head.
Guitar cabinets: The D2 can be placed within 1-2 inches of the grill cover at a 90 degree angle
pointing directly into the speaker. If the mic is placed closer to the edge of the speaker, you will
minimize the higher frequencies and get a warmer, fatter tone. To capture more highs, move the
mic closer towards the center of the speaker, but avoid the middle of the speaker.
Horns: Place the mic within 1-2 inches of the bell, especially when on a stage with drums, bass,
guitar, etc. For jazz, classical, and music where the stage volume is lower, the mic can be placed
further away for a richer, fuller sound.
*Further miking techniques may be found on our website at www.audixusa.com
FREQUENCY / POLARS:
***All specications subject to change without notice.
To register your
microphone, please visit
www.audixusa.com
DIMENSIONS (mm):
D2
Transducer Type Dynamic
Frequency Response 80 Hz - 18 kHz
Polar Pattern Hypercardioid
Output Impedance 250 ohms
Sensitivity 1.2 mV / Pa @ 1k
Capsule Technology VLM Type B
O Axis Rejection >30 dB
Maximum SPL ≥144 dB
Power Requirements None
Connector Switchcraft® male
XLR connector
Polarity Positive pressure on diaphragm
produces positive voltage on pin 2
relative to pin 3 of output
XLR connector
Housing / Finish Machined Aluminum /
Black Hard Coat
Weight 128 g / 4.5 ounces
Length 100 mm / 3.9 inches

Termékspecifikációk

Márka: Audix
Kategória: mikrofon
Modell: D2

Szüksége van segítségre?

Ha segítségre van szüksége Audix D2, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók mikrofon Audix

Audix

Audix ADS48 Útmutató

29 December 2024
Audix

Audix M63 Útmutató

3 Szeptember 2024
Audix

Audix M45 Shortgun Útmutató

3 Szeptember 2024
Audix

Audix M55D Útmutató

30 Augusztus 2024
Audix

Audix M40 Útmutató

28 Augusztus 2024
Audix

Audix M55WO Útmutató

19 Augusztus 2024
Audix

Audix M40W12HC Útmutató

19 Augusztus 2024
Audix

Audix OM2 Útmutató

19 Augusztus 2024
Audix

Audix Fireball Útmutató

19 Augusztus 2024
Audix

Audix M3WHM Útmutató

19 Augusztus 2024

Útmutatók mikrofon

Legújabb útmutatók mikrofon

Røde

Røde NT1 Signature Series Útmutató

10 Április 2025
Genesis

Genesis Radium 400 G2 Útmutató

9 Április 2025
Ambient

Ambient TinyMike ATM216 Útmutató

9 Április 2025
Ambient

Ambient Sound Fish ASF-1 MKII Útmutató

9 Április 2025
Ambient

Ambient ASF-G Útmutató

9 Április 2025
Ambient

Ambient Soundfish 2 MkII Útmutató

9 Április 2025
Ambient

Ambient UMP III Útmutató

9 Április 2025
Comica

Comica VP3 Útmutató

2 Április 2025
Atlas Sound

Atlas Sound MWHHM Útmutató

2 Április 2025
Synco

Synco G2A1 Útmutató

2 Április 2025