Használati útmutató Audac WX302/O

Audac hangszóró WX302/O

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Audac WX302/O (4 oldal) a hangszóró kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/4
PROFESSIONAL AUDIO EQUIPMENT
Outdoor Wall Speaker WX302/OB-OW
User Manual &
Installation Guide
Outdoor Wall Speaker
WX302/OB-OW
AUDAC
1
Warning
Only use the correct amplifier output voltage and impedance. Exceeding these limits could
cause fire or other failures.
Avoid explosions: do not use the speaker around gasoline, thinner or other combustibles.
Only install the speaker in locations that can structurally support the weight of the speaker.
Not doing so may result in the speaker falling down.
Do not use any other method than specified to mount the speaker. If extreme force is applied
to the speaker, the speaker could fall down.
Attach a safety wire to the speaker when it’s mounted high above the ground. Failure in doing
so could cause the speaker to fall down for any reason.
Avoid mounting the speaker in locations exposed to constant vibrations. The mounting points
can be damaged by excessive vibrations, potentially causing the speaker to fall down.
Caution
Avoid electric shocks: switch off the amplifier power when connecting the speaker.
Avoid installing the speaker in locations exposed to solvents, acids, smoke and heaters, as
excessive exposure to these factors could result in speaker failure, fire or electric shocks.
Do not operate the speaker for an extended period of time at distorted sound. This could
cause (irreparable) damage to the speaker.
Do not stand or sit on, nor hang down from the speaker as this may cause failure of the
speaker.
2
Installing the WX302/OB-OW
Mounting the loudspeaker
The loudspeaker can be mounted both horizontally and vertically by means of the supplied
mounting bracket. For mounting the loudspeaker on the desired mounting location, the mounting
bracket should be removed from the loudspeaker. This can be done by loosening the screws on
either side of the loudspeaker. After this is done, the mounting holes should be indicated. For a
stable mounting of the loudspeaker it should always be fastened by two screws. The position of
the mounting holes depends of the mounting position, horizontally or vertically with a spacing of
107 mm in between. After this, the bracket can be mounted on the desired location. Always use
the proper fasteners depending of the mounting surface.
Once the bracket is mounted on the desired location, the loudspeaker can be fixed to the bracket.
Connecting the loudspeaker
On the rear side of the WX302/OB- is a special waterproof AWX-5 connector provided. OW
This allows to connect the loudspeaker to the amplifier output. A special included connection
cable should be used. Always connect the white conductor of the connection cable to the COM
output of the amplifier and the black connection terminal to the positive terminal of the amplifier
output.
Mind the polarity markings when wiring the loudspeaker cables.
Power settings
The power settings of the WX302/OB- can be made by rotating OW
the waterproof connector on the rear side of the loudspeaker. On the
cable part of the connector is a white dot displayed. Depending of
the position of the white dot, the desired power can be selected. The
corresponding powers are shown on the sticker on the rear side of
the loudspeaker. The power / impedance of the loudspeaker can be
set in 3 adjustable steps of impedance for 100V ( Watt, Watt, 5 20 10
Watt) and 1 step for 8 Ohm standard low impedance applications.
1) 30 8 Ohm / Watt
2) 20 500 Watt / Ohm
3) 10 1000 Watt / Ohm
4) 200 5 Watt / 0 Ohm
When the loudspeaker is connected to 70.7V facilities, the power indicated in the table above
will be reduced to half the power, and when connected to 50V facilities, the power will be
reduced to a quarter.
10W
20W
8Ω
5W
1 kΩ
0.5 kΩ2 kΩ

Termékspecifikációk

Márka: Audac
Kategória: hangszóró
Modell: WX302/O

Szüksége van segítségre?

Ha segítségre van szüksége Audac WX302/O, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók hangszóró Audac

Audac

Audac ARCHI210 Útmutató

30 Március 2025
Audac

Audac ARCHI10 Útmutató

30 Március 2025
Audac

Audac CIRA724I Útmutató

18 December 2024
Audac

Audac ATEO6M Útmutató

18 December 2024
Audac

Audac WS500 Útmutató

6 Október 2024
Audac

Audac ATEO4 Útmutató

4 Október 2024
Audac

Audac MERO2D Útmutató

2 Október 2024
Audac

Audac MERO6 Útmutató

2 Október 2024
Audac

Audac CENA710D Útmutató

28 Szeptember 2024
Audac

Audac CIRA724 Útmutató

28 Szeptember 2024

Útmutatók hangszóró

Legújabb útmutatók hangszóró

Crestron

Crestron SAROS ICE4T Útmutató

7 Április 2025
Crestron

Crestron SAROS ICI6T Útmutató

7 Április 2025
Focal

Focal K2 Power M FRAK Útmutató

5 Április 2025
Match

Match UP C42BMW-FRT.3 Útmutató

3 Április 2025
Turbosound

Turbosound PQ12-SB Útmutató

3 Április 2025
Trust

Trust Tytan GXT 658 Útmutató

3 Április 2025
Turbosound

Turbosound PQ15-YB Útmutató

3 Április 2025
Klipsch

Klipsch Synergy KSB-S1 Útmutató

3 Április 2025
Klipsch

Klipsch Synergy KSF-10.5 Útmutató

3 Április 2025
Klipsch

Klipsch kO-R1 Útmutató

3 Április 2025