Használati útmutató APC NBES0307

APC szerver NBES0307

Olvassa el alább 📖 a magyar nyelvű használati útmutatót APC NBES0307 (4 oldal) a szerver kategóriában. Ezt az útmutatót 4 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/4
NetBotz® Smoke Sensor (NBES0307)
Installation Instructions
WARNING: The NetBotz Smoke Sensor is intended to provide supplementary
protection for equipment in data center racks and enclosures only. It is not to be
used to protect structures or personnel.
This Smoke Sensor includes a System Senso model 4W-B, I3 Series, Photoelectric
Smoke Detector. For complete safety, installation, operation, and maintenance
information, refer to the I3 Series Installation and Maintenance Instructions on the
System Sensor Web site, www.systemsensor.com.
Inventory
Smoke sensor with 3.05-m (10-ft)
cable (1)
M4 x 8 pan head screw (2) M6 black plastic cup
washer (2)
Smoke sensor bracket (1) M6 x 16 Phillips slot screw (2) M3 knurled thumb nut (2)
203-mm (8-in) tie wrap (10) Adhesive cable tie holder (5) M3 x 12 stud fastener (2)
RJ-45 coupling (1)
NetBotz Smoke Sensor (NBES0307) Installation Instructions2
Installation
Caution: Make sure you connect this sensor to a Sensor port on applicable NetBotz
products. See your NetBotz product documentation for details.
Caution: Make sure you remove the orange protective cover shown in step three.
Note: Smoke detection is best when you install the sensor near the top of the enclosure. The
sensor occupies one U-space.
Note: You can extend the length of the sensor cable up to 30.5 m (100 ft) using the
RJ-45 coupling and standard CAT-5 cabling.
Note: Use adhesive cable tie holders and tie wraps to secure the sensor cable.
OR
NetBotz Smoke Sensor (NBES0307) Installation Instructions 3
Operation
The Smoke Sensor LEDs function as follows:
Both LEDs will blink simultaneously once every ten seconds during the power-up sequence.
The green LED will blink once every five seconds to indicate normal operation.
The red LED will blink once every five seconds to indicate that the Smoke Sensor is out of
sensitivity.
The red LED will turn on when the Smoke Sensor reports an alarm state.

Termékspecifikációk

Márka: APC
Kategória: szerver
Modell: NBES0307

Szüksége van segítségre?

Ha segítségre van szüksége APC NBES0307, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók szerver APC

APC

APC RBC55 Útmutató

14 December 2024
APC

APC AP8653 Útmutató

8 December 2024
APC

APC BK650EI Útmutató

18 Szeptember 2024
APC

APC PNET1GB Útmutató

9 Augusztus 2024
APC

APC BK500EI Útmutató

5 Augusztus 2024
APC

APC APBX700UI Útmutató

4 Augusztus 2024
APC

APC APBE550G-UK Útmutató

29 Július 2024
APC

APC APBK500EI Útmutató

27 Július 2024
APC

APC SUA5000RMI5U Útmutató

25 Július 2024

Útmutatók szerver

Legújabb útmutatók szerver