Használati útmutató Antennas Direct ClearStream

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Antennas Direct ClearStream (2 oldal) a Tv-antenne kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/2
1) Reflector with
Collapsible Dipole
and Loop Element Base
2) Loop Element
3) 3 ½” Bolt
4) Weather Boot (optional)
Required, not included: Coaxial Cable, Medium-sized Cross Point Screwdriver.
3
4
Thread coaxial cable A with the connected weather boot through
the VHF IN hole in the Loop Element base (1) and connect cable
to the VHF IN connector on back of the Loop Element (2).
Once connected, slide the weather boot over the connection.
Secure the Reflector with Collapsible Dipole, Loop Element
Base (1), and Loop Element (2) as shown using the 3 bolt.½
Position the Loop Element Base at the center of the Reflector
Assembly bar until holes are alligned.
1
2
3
Thread coaxial cable through the TO TV hole
in the Loop Element Base (1) and connect the
cable to the TO TV connector on the back of
the Loop Element (2).
A
©Antennas Direct 2012 06/12 C2-V
Connect opposite end of coaxial cable to your TV or receiver.
Locate your TV Station transmission towers by going to
antennapoint.com and search on your address or zip code.
Point antenna in the direction of the transmission towers
closest to you and check reception by scanning for channels.
If reception is not as desired, move antenna and rescan.
Please call our Helpline for additional information.

Termékspecifikációk

Márka: Antennas Direct
Kategória: Tv-antenne
Modell: ClearStream

Szüksége van segítségre?

Ha segítségre van szüksége Antennas Direct ClearStream, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók Tv-antenne Antennas Direct

Útmutatók Tv-antenne

Legújabb útmutatók Tv-antenne