Használati útmutató AKG PZM-10

AKG mikrofon PZM-10

Olvassa el alább 📖 a magyar nyelvű használati útmutatót AKG PZM-10 (2 oldal) a mikrofon kategóriában. Ezt az útmutatót 12 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF

Oldal 1/2

PZM 10 (LL)

he A K G / C r o w n PZM10 is a Pressure

Zone Microphone

® desi ed for gn

rity, surveillance, and conference-

table use.

PRESSUREZONE

MICROPHONE

Si e it nc does not l k oo like a microphone, it is

inconspicuous. The mic’s t lar housi ubu ng

mounts in a 25/32" diameter hole in a ceiling

panel, wall or table.

Like other Pressure Zone Microphones, the

0 es a miniature mic capsulus e

mounted very near a sound-reflecting plate or

boundary, in the Pressure Zone. In this zone,

ect sound from the sound source combines

in ase at all eph fr quencies with reflected

sound o the boundary. The benets are

: 6 dB more sensitivity, 6 dB less noise, a

wide smooth efr quency response ee ofr f

phase interference, excellent clarity and

“

r ,each

” and consistent pickup anywhere

around the mic.

In the M10, low ePZ fr quencies below the

ice ra

nge are rolled o to reduce pickup of

air conditi ing rumble. The hi - eon gh fr quency

response is boosted slightly to help articula-

cause of its tailored response and PZM

constr , the 0 wuc onti PZM1 ill pick up conver-

s or other desired sounds with extra

clarity and definition.

The microphone connector is an XLR t e yp

(3-pin pro audio) for easy pl -in i taug ns llation.

The

ou put

t is balanced, low i edamp nce, which

s long cable r s wun ithout hum pickup or

hi - egh fr quency loss. Powering is by 12 to

48 V phantom power.

The PZM10 LL has a line level output.

The mic’s humbucking transformer and steel

case prevent hum pickup, even near fluores-

cent lights.

Installation

To pick up speech at a small conference table

(about 6 f t square), mount e 0 iee on PZM1 n

the mi le of the table. For longer tables, dd use

M in the middle of every 4 to 6 people.

No person should be more than 3 f t om ee fr

the nearest microphone.

1. Pl se refer to Fig. 2 and identify the paea rts

shown.

termine ere u want to iwh yo nstall the

microphone, and drill a 25/32" diameter hole

Specifications

nsducer type:

Electret condenser.

ency response (typical): 80 Hz to ,000 20

Hz. See Fig. 1.

Polar pattern: Hemispherical.

I edance: mp 240 ohms, balanced. Recom-

ed mini m load i edamu mp nce 1000

ohms.

Open circuit sensitivity:

2.5 mV/Pa* (–52 dB V/ ). Pa

Power sensitivity: –52 dBm/Pa*

ivalent noise level (self- ise): no

26 dB SPL t ical (0 dB = 0.0002 dyne/cmyp 2),

A-wei ted. gh

S/N Ratio: 68 dB at 94 dB SPL.

xi m SPL: mu

120 dB SPL produces 3% THD.

Operating vol ge: ta 12 to 48 V phantom power,

pos

iti

ve voltage on pins 2 and 3 with respect

to pin 1.

l ity: ar

Positive pressure on the diaphragm

pr es a itive age on pin 2 woduc pos volt ith

ect to pin 3 of ou put t connector .

rre

nt drain: 400 microamperes.

Output connectors:

PZM10: Ma le XLR t e (3-pin pr ayp o udio).

PZM10 LL: Line level output,

unterminated cable.

Cable: None supplied. Use 2-conductor shielded

mic cable.

Materials: St l plate and housi . ee ng

Fini : sh Off- e. May be painted any whit color; take

care to rst seal the ening betwop een the

capsule and boundary plate.

Net wei t: gh 2.6 oz. ( .6 g). 73

Dimensi s: on See Fig.2.

Fig. 1

Fig. 2

quency Response

quency in Hz

there. * 1 pascal = 10 dynes/cm2 = 10 microbars = 94 dB SPL.

3. Obtain some 2-conductor ielded mish c

cable, l g enough to run om your eon fr quip-

ment input to the microphone. If space is ti t gh

behind the mounting rface, tain a t- su ob righ

le female XLR connector. Solder the fe-

male XLR connector to the cable: on shield to

pin 1, hot l d to pin 2, other l d to pin 3. ea ea

4. Run the female XLR and mic cable to the

hole.

Using a 5/ " A32

llen wrench, remove the

from the microphone. I ert the micro- ns

phone tube into the hole.

lide the collar to the mic t e. Pull thon ub e

plate tight agai t the ns hole and press the collar

t agai t the mounns ting rface. Ti tesu gh n

the Allen screw in the collar.

7. Plug your mic cable into the microphone.

8. Plug the other end of your mic cable into

one of these devices:

* A mic pr mp that suppea lies phantom power.

* A mixer that supplies phantom power.

* A

antom power supply, such as the A K G /

C r o w n PH4B or PH1A.

Connect the out t of the supply to the mipu c

i t of your mic pr , mixer or renpu eamp corder.

i ctste

’ and Engineers’ Specifications

The microphone shall be the A K G / C r o w n

M10 or e

quivalent. The microphone shall

be a electret condenser Pressure Zone

Microphone with a hemispherical polar

ern. The microphone shall have a tubular

housing whi mounts in a ch 25/32" diameter

le. Open-cir

cuit sensitivity shall be 2.5

mV/Pa typical. Equivalent noise level shall be

26 dBA t ical. Maxi m yp mu SPL shall be

120 dB for 3% THD. Powering shall be 12-48

antom power. Out connector put shall be

male XLR-t e. yp

The A K G / C r o w n PZM10 microphone is

specied.

Warranty

A K G / C r o w n professi al microphones are on

guarant d unconditiee onally agai t ns

unc

tion from any cause for a period of

three years from dat of oe riginal pur ase. ch

Pl se refer to the eea nc osl ed full warranty

statement for more detail.

Service

If the unit fails to work, first replace or repair

the mic cables and check the power supply. If

you determine that the microphone

product is defective, return the

complete product in its original

packaging to one of the addresses

below. For further assistance or

technical support call the international

helpdesk at +43 676 83200 888.

PZM10 Schematic

AKG ACOUSTICS GMBH LAXENBURGER STRASSE 254, 1230 VIENNA/AUSTRIA

AKG ACOUSTICS, U.S. SERVICE 24950 GROVE VIEW ROAD, MORENO VALLEY, CA 92551, U.S.A

and/or other countries.

Features, specications and appearance are subject to change without notice.

www.akg.com

PZM10 (LL)

Termékspecifikációk

Márka:	AKG
Kategória:	mikrofon
Modell:	PZM-10

Szüksége van segítségre?

Ha segítségre van szüksége AKG PZM-10, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek

Az Ön neve*

Az Ön e-mail címe*

Írja ide kérdését

Útmutatók mikrofon AKG

11 Január 2025

13 Október 2024

8 Október 2024

29 Szeptember 2024

14 Szeptember 2024

10 Szeptember 2024

9 Szeptember 2024

4 Szeptember 2024

1 Szeptember 2024

AKG Sound Grabber II Útmutató

1 Szeptember 2024

Útmutatók mikrofon

Legújabb útmutatók mikrofon

Røde NT1 Signature Series Útmutató

10 Április 2025

Genesis Radium 400 G2 Útmutató

9 Április 2025

Ambient TinyMike ATM216 Útmutató

9 Április 2025

Ambient Sound Fish ASF-1 MKII Útmutató

9 Április 2025

Ambient ASF-G Útmutató

9 Április 2025

Ambient Soundfish 2 MkII Útmutató

9 Április 2025

Ambient UMP III Útmutató

9 Április 2025

Comica VP3 Útmutató

2 Április 2025

Atlas Sound MWHHM Útmutató

2 Április 2025

Synco G2A1 Útmutató

2 Április 2025