Használati útmutató ADDAC System ADDAC105

Olvassa el alább 📖 a magyar nyelvű használati útmutatót ADDAC System ADDAC105 (5 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 6 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/5
ADDAC105 4 VOICE CLUSTER USER’S GUIDE
October.2019Revision.01
Welcome to:
page 2ADDAC SYSTEM
OVERALL FEATURES
Following our ADDAC103 T-Networks this new module is inspired by it’s simplicity. This is a 4 voice
Square Oscillator with VCA, FM switch and a slew decay for the incoming Trigger input. All voices are
then mixed and processed through a Multimode Filter.
Each voice has it’s own VCA input where any input is accepted (Trigger, Gate, CV) The [DECAY] controls
the slew decay applied to the incoming signal, if [DECAY] is fully anti-clockwise then it also works as a
Mute.
The [FM ON] switches activate/deactivate the FM input coming from the previous voice: Voice 1 FM comes
from voice 4, voice 2 FM comes from voice 1, and so on, so you can FM all of them in a FM loop.
All 4 voices are summed and sent through a filter with controls over [CUTOFF] with an Attenuverter for
the CV input and [RESONANCE]. Three filter outputs are provided [LOWPASS], [BANDPASS] and [HIGHPASS]
The [EXTERNAL IN] input can be routed through a jumper on the back of the module allowing the incom-
ing signal to go to:
1. the filter input for processing an external audio source.
2. all of the 4 voices Frequency control allowing for some experimental CV control over pitch of all 4
voices at the same time (due to the specificities of the circuit and to keep the module at a low price
these inputs are not callibrated to 1v/octave).
Tech Specs:
8HP
4.5 cm deep
40mA +12V
40mA -12V
CONTROLS DESCRIPTION
ADDAC105 User’s Guide
page 3ADDAC SYSTEM
Frequency
Tune the Pitch for each voice
Sets Filter Cutoff Frequency
Independent trigger inputs
Cutoff CV Attenuverter
Sets polarity and gain of incoming
CV input
Sets the slew Decay
for each voice
FM on/off switch
Sets Filter Resonance
Bandpass Filter Output
Filter Cutoff CV Input
This input can be routed to send:
1. Audio signal into Filter
2. CV signal to Frequency control
Highpass Filter OutputLowpass Filter Output

Termékspecifikációk

Márka: ADDAC System
Kategória: nincs kategorizálva
Modell: ADDAC105

Szüksége van segítségre?

Ha segítségre van szüksége ADDAC System ADDAC105, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók nincs kategorizálva ADDAC System

Útmutatók nincs kategorizálva

Legújabb útmutatók nincs kategorizálva